Search results for query: *

Thanks for the info everyone. Excuse my ignorance but which terminals are you refering to? I would guess the two center pins would be the 1st pair and the outer two would be the second.

I have read several posts about this but need clarification if possible. I would like to connect an external powered ringer to the headset port of a m7208 set. Is this possible without some sort of digital device?

Sorry to inconvenience everyone. Ended up being an application problem that the vendor had assured me time and time again was a firewall problem. I would like to note that I never did get nat to allow the internal host to send out a packet at the original port. ie source port seems to be...

I want to be able to allow a host on the internal network to connect via a specific port xxxx. The inside net is currently using a nat overload on a single ip. I have tried static nat setup with specific port info and adding that ip/port combo to a deny statement in the dynamic nat access...

I am sorry, apparently the amphenol connector was not seated completey because of a screw in the housing. Sorry to waste your time.

I just purchased a CICS. I can hookup a phone to port 101 and the phone works fine (as least i can get into the config from it). If I hook up to any other internal port on the system the phone never comes on and in maintenance it shows not equiped. Anyone have any ideas that might help me...