Search results for query: *

Thank you All

try DTE procedure on thee Digital module and do a AT-X1 erase this can happen if modules have power interrupted during upgrade on first boot

One Hour to upgrade the SD card from 6.1.5 to 7.0.5 via UpgradeWiz

Try this if is new install Change System Name and IP Address on LAN and / or Disable DHCP Server Send config Reboot Then upgrade Know it sounds odd, but it works for me

Update Had to reprogram the whole system from scratch to fix this issue

sure, where too ?

numbering the button in action data does make the light work still no "G" in the display Still need one button to place user in to busy wrap up for multiple hunt groups.

No action data, generic Hunt Group Enable

have a 406v2, analog 8 (Extn), digital 16v2 with 60R1 power supply 35 users built 113 hunt groups 121 incoming call routes have an issue with a agents' HgEna (hunt group enable) button not working and there is no "G" in the display the normal phone is a 4424 but have swapped with a 5420...

no the pri is in pool 890, and there are no trunks in 70. apparently ther was lines in pool 70 but they have been droped and now they are wanting the 911 calls to go over the pri. am asking if there is a way ( toehr than renumbering the pri pool to 70 ) to make 911 calls over the pri

have a Legend R3 and trying to set up the 911 calls going out to go over the PRI pool 890. The PRI is the only Co they have. know that the special number table ( 20 ) will not allow chages to the out going pool. is there away around this???? thanks