Search results for query: *

Doug is correct It must reach your firewall first. In your case you would want your VPN tunnel to terminate at the PIX.

To use nat (non vpn) you will need another valid internet address so that the router can nat it through to an internal address. For a VPN option you will need to get the ip firewall/vpn feature pack for your router.

In a set up as simple as this I usualy have the ser interface unnumbered against the ether interface as it is nice and simple. interface serial0 ip unnumbered ethernet0 (on both routers) ip classless ip route 0.0.0.0 0.0.0.0 ser0 (on bopth routers)

Hi all, I have 2620 with a 2ce1u with and aggregate bearer on one interface (leased lines) and an ISDN30 with 10 channels (as backup for the leased lines). I have my leased lines configured and working great but need some advice on a basic config for the ISDN30 to back up the leased lines...

Hi all, I very new to Checkpoint and need some good sites/docs that expain config from start to finish including example rule bases. If any1 knows of any please reply. Thx

Thanks for your respones. I found out the problem. We were using an un-balanced card, on an x21 interface at the NTU. The un-balanced card will only support BNC. BT did terminate on the x21 and are now moving it to the BNC. If BT's network was a balanced network we would have used a balanced...

I have a PRI/2CE1u card in a 2620. I have been having a lot of trouble getting it to work with an aggregate bearer (10 x leased lines on one interface). BT inssist the line is ok and I am pretty sure my config is ok. My understanding of the 'Local Alarm' LED on the controller means that no line...

I have a PRI/2CE1u card in a 2620. I have been having a lot of trouble getting it to work with an aggregate bearer (10 x leased lines on one interface). BT inssist the line is ok and I am pretty sure my config is ok. My understanding of the 'Local Alarm' LED on the controller means that no line...

hey all, just looking for some config examples (or sites relating to). Especialy 1's relating to a 2600 as an external router on a 2mb x.25 interface, serial with a checkpoint ng server on the inside!?! Cheers

Thx Guys, I'll give it a try, the interface card is a NW-2CE1B, It will be taking 10 Leased lines (of various speeds). It will definatly be using time slots i.e. 1 slot for a 64k and 2 slots for a 128 etc. I just want to be on the safe side. Cheers

I'm pretty sure you would need a network module. I think it would be a NW-1CT1.

Hi all, I am looking for advice on the above. I have 10 1601's (with serial) connecting back to a 2620 with a dual E1 Channelised interface. If anyone can give me advice on the config of the E1 interface it would be great. I have a rough idea but have never had to config one of these before and...