Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Channelizing on Cisco T1

Status
Not open for further replies.

RobG2001

MIS
Oct 5, 2001
89
US
If I wanted set up two vlans on network, each to use a certain amount of bandwith of a private T1, how would it be done? Could I use the channel-group command and if so, what kind of WIC would be required? Any help would be appreciated.

RG
 
I'm pretty sure you would need a network module. I think it would be a NW-1CT1.
 
not sure what your setup is, but you can always use custom queuing. 50% of bandwidth for vlan 1, 50% for vlan 2. can only do this if each vlan comes into the router on different interfaces
 
What type of router do you have? “Reserve your right to think, for even to think wrongly is better than not to think at all”

Fisher CCNA
[americanflag]
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top