Search results for query: *

set hotline to 0

I probably didn't put my statement correctly. Just like KX-NS500, if you have access to the Backup config saved on some storage device , you can open it and read the paasword. However some versions may still require you to have the password to open the backup file. Do as OBT has advised above.

If you can access the memory card where data is/was stored you could retrieve the password, otherwise reset and reprogram.

Which phone are you using?, Have you assigned the line on the phone button ? Has it worked before or its a new installation?

What about Extension to CO duration?.

Program No. 4.1.1 Intercept No Answer Time, Am not sure how many seconds corresponds to 2 Rings - You can try 10seconds. Also check Intercept Destination -> And look at "When called party does not answer" destination

Have you checked these two in the SPA8000, PSTN-To-VoIP Call Max Dur & VoIP-To-PSTN Call Max Dur Also in the KX-TDE, check out 3.1.1. Extension to CO Duration time.

On KX-TDE100 , Reverse detetion select both calls In SPA8000 lockout for "Detect Polarity Reversal

Both the Panasonic KX-TDE100 & SPA8000 have signal detection features. To the KX-TDE100, SPA8000 is the Telco (POTS Line provider). And to the SPA8000 your your VoIP Provider is the ITSP. In my understanding, the FXS Ports on the SPA8000 (are merely SIP extensions converted to Analog) from the...

Ain't you supposed to enable ability to forward call to CO for that extension?. Under 4.1.2 Then set the Ext to COS1

Directs an incoming trunk call to a preprogrammed destination when the caller's identification number (e.g.,Caller ID) matches the number in the System Speed Dialling Table that is used as the Caller ID Table. Each Caller ID number (telephone number for each System Speed Dialling number) can...

what have you done so far and what problem are you facing?

The two systems support SIP Trunking, NO license required. Trunk them up and setup ARS

I would suggest that you contact your dealer/PBX Vendor.

Do the same with the TDA30

Upgrade KX-TDA30 to Ver5.01

Upgrade both the PBX and DHLC/DLC

Have you got a SIP Trunk License on the KX-NS500? Have you looked at the SIP Trunk setup guide of the KX-NS500?https://files.engineering.com/getfile.aspx?folder=48918c04-cfbf-402d-ad53-e25d0702d337&file=KX-NS500_SIP_TRUNK_SETUP.pdf

Change CO Line access to "0" then set speed dial 911 to dial 911

Xlite will do - Tested