Search results for query: *

all aastra products will kept as it is but with some changes for example mx-one to be Mi voice mx-one aastra mobile client will be mitel mobile client only names will changes

anyone know about mmtrace? or how i can trace calls between two extensions please....... Thanks

Hi All i have a problem with one box after created one box call processor i import audio message how i can make it as main greeting instead of original greeting of the system Note: audio message created and imported successfully according to rules of audio messages of mail box configuration.

Hi try to restart program unit of digital extension KLP1T and KLP1D by command RFPUI:untit=KLP1T,LIM=ALL; and same command for KLP1D and if your PBX is MX-One TSE use command restart -u KLP1T -l 1 and same for KLP1D Please test all position from ELU card directly by MDF Cable

Hi baniamb, you must upgrade Mx-one TSW to MX-One TSE to have ability to make SIP trunk note: SIP trunk is supported only in MX-One TSE (Telephony Server). Best Regards,,

yes how can i configure fax mail server on a470 any help????

also boardid is missing

i have a problem when upgrading firmware of MGU i used this command board_sw -gateway -netload -path mgu/16.27.1 -protocol http -host 192.168.1.2 -mgw 1a It shows an error : no server found where host is the ip of the telephony server TS directory: /usr/firmware/mgw-16.27.1.rpm Please any help

hello all anyone knows how aastra mobile client register on A470 without aastra portal in the new release of AMCC their is no need to aastra portal any advise????

Hello all anyone can help me with astra 470 ? I had a serious problem thanks

when i turn on there is no anything available on the screen to insert ip of tftp server,but i can ping on it through the network please what i can do with it?? i use tftp server by solar wind

Please i have a problem with 7965 i used to total hard reset to the phone with code 3491672850*# and it seems it lost firmware and all configuration files also. and when i turned it on i just flashes only and still no display available any help please???

firtstly u should connect tmu board with moh cable to any audi device then with the command recorded voice announcement to every extension RADNI , RACEI

try the command dusyi:print=result; if it isnt successful may be lim 3 is out of order so print synchronization and group switch if it is used

but firstly dont forget to take a generation from the pbx before initial load

u are going to make a initial load and create a new password

mx-one with ipphone sw sever

any help????????????????

how i can create ipphone sw server to configure blustar for the first time or any another solution to configure it ??????

yes i already marked it