Search results for query: *

Thanks Kevin, I'll take a look at that also...can I do that for individual numbers? I'll need about 20 numbers out of around 1300 to have the ability to dial int'l r Fred

Thanks BSH, I need to allow certain folks the ability to dial overseas...would that be done in the COR? R Fred

Can anyone tell me how to block overseas calling capabilities on extensions. I suspect it is a class of restriction issue? any help us much appreciated! r Fred

Thanks BSH, So when I access the server how can I reset the root p/w? appreciate the assist! r Fred

Can anyone tell me the best way to get the root p/w's from my servers? Have a CM 4.0....Any help is appreciated.

Can anyone tell me if I can have another phone number input to my spectel conf bridge? I have an Avaya CM4.0 switch, the bridge was installed about 10 years ago when they went to a G3R. Any help is appreciated. Fred

Thanks all....yes these are analog lines...I'll give it a try...although the EM wants red phones.... appreciate it....

They are going to be auto dialer emergency phones GB90VS02Y

Hi, Can anyone help me with setting a ringdown/hotline up?...Need 2 phones set up outside an ER so when someone picks up either one of them it rings to a desk in the ER..Any help is much appreciated. Fred

Ratman, that seemed to work...many thanks... Fred

I'll give it a shot....thanks again...appreciate it!

Thanks Bob & Ratman..I have an Avaya CM 4.0 so what would I enter to remove that ? is there a feature button for clearing amw?....I have another station that has the permissions just cant seem to get the entry to make.... :(

Hi, I have a customer with a constant MWL on her 7400 series phone. I was thinking this is a LWC issue but I cannot get the light to extinguish. Not sure if its a message retrieval issue but not sure how to get rid of it. Any ideas? All help is appreciated! Thanks, Fred

Thanks BSH....appreciate it!! good to know information...

Thanks for the assist...I did a disp ds1 and am showing protocol version a on my pri's..which according to your chart is AT&T custom...I was looking for whether we had NI1 or NI2...I'll try and find what AT&T custom is... Thanks again jordy & mojo.....

Hello, Can anyone tell me where I would verify where the NI-1 or NI-2 settings would be? I am on an Avaya CM4.0 I've looked at the trunk (disp trunk) but not seeing it..appreciate any assistance... Fred

The dadmin was set as prof2 and the new login name was also prof2 but still get the screen to enter new pin when I enter a new pin for the new login it either says to re-enter it then tells me its incorrect or it just says incorrect pin... ideas?....thanks Fred.

I did check to ensure that "y" was selected in the system-parameters and it was. Still unable to enter a valid pin for some reason. A new profile was added with a name change and I can get past the first log in but it asks for a new pin each time with the same result "invalid pin" I am using...

When I attempt to log on to my switch I enter a login and p/w I then need to enter a pin. Being I changed the login from dadmin, it asks for a new pin but every time I enter a new pin I get an "invalid pin" response. Can anyone tell me what I am missing or doing incorrectly? Again; appreciate...

Thanks to Mojoputter and BSH for your answers....most appreciated!