Search results for query: *

THANKS FOR THE RESPONSE, THE VOLTAGE IS CLOSE TO ZERO FOR BOTH BANKS. AFTER DOING A BIT MORE READING I SEE NOW THAT THE BATTERIES AREN'T NECESSARY FOR THE SYSTEM TO RUN AND SINCE THEY REALLY DON'T PROVIDE MORE THAN 5-10 MINUTES OF BACKUP THEY CAN BE REMOVED. I HAVE BATTERY COMPANY COMING...

HI. DC POWERED MERIDIAN PBX WITH TWO BANKS OF BATTERIES. ONE BANK HAS 3 BATTERIES THAT HAVE CRACKED AND HAVE CORROSION. NEED PBX FOR 3 - 4 MORE MONTHS WHILE WAITING FOR CIRCUITS TO REPLACE ISDN LINES USED AS CIRCUITS. IS IT POSSIBLE FOR THE PBX TO RUN IF ONE BANK OF BATTERIES IS REMOVED...

HI. I PROVIDED TELCO LEC/AT&T TECH THE CIRCUIT ID AND HE WAS ABLE TO TELL ME THE LINE CODING. I CONFIRMED PBX LINE CODING IN CEQU. I DON'T UNDERSTAND HOW ITS BEEN WORKING EITHER, BUT IT HAS BEEN FOR MANY YEARS. I DON'T HAVE A T-BERD UNFORTUNATELY. I'VE HAD UNSCHEDULED POWER OUTAGES BEFORE...

FORGOT TO SHARE THAT PBX IS OPTION 81C, RLS 25.30 THIS IS A STRAIGHT T1, NO D CHANNEL, WOULD THERE STILL BE AN ADAN ASSOCIATED WITH IT?

HI. POWER OUTAGE AND PBX DOWN. PBX BACK UP BUT T1 (NOT A PRI) FOR DSN/ATVN SERVICE, ENABLED BUT WON'T CONNECT TO FAR END, CALL DOES NOT COMPLETE. TESTED CABLING BY UNPLUGGING CABLES FROM CSU TO PBX AND T1, T1 QPC720E CARD, GOES RED, PLUG BACK IN AND GREEN. UNPLUG NETWORK CABLE AT CSU...

CNIs REPLACED AND ENALED WHEN GOING THRU PROCESS AND GET TO THE BELOW, LD 135 DOES NOT SHOW US IN SPLIT MODE STATTED CPU, MEM, AND CNI AND NO INDICATION OF SPLIT MODE INACTIVE CNIs SHOW ENABLED EVEN THOUGH WE DISABLED AT THE CARD. WHAT DID I MISS? USE THE FOLLOWING PROCEDURE. CHECK WHICH IS...

HI. THANK YOU FOR GETTING BACK TO ME. I'VE NOT SPLIT MODES BEFORE BUT WILL BE WORKING WITH FORMER NORTEL TECH. NEED TO GET YOU HERE WITH US. I'M LOOKING AT THE CNIs RIGHT NOW. I GET THE BELOW WHEN I STAT. DOING TEST DIAGNOSTIC, IN CASE CNI CARD BAD. ANY INFO YOU CAN SHARE IS GREAT...

HI. PBX ON LAST LEGS, BAD CORE, WENT DOWN HARD TODAY. PBX IS BACK UP BUT WITH ISSUES. SO MAY ERRORS GETTING IOD 041. HOW DO I CLEAR IT TO SEE THE ALARMS? MY HOPE IS THAT MOST OF THE ERRORS/BUGS THAT FILLED THE BUFFER HAVE CLEARED BUT THAT MAY BE WISHFUL THINKING. INFO GENERATED NOW MAY...

THE CC CARD SHOULD BE IN STANDBY WHEN IT IS DISABLED CORRECT. I'VE NEVER REPLACED A CLOCK CARD BEFORE, A BIT HESITANT. ADDITIONALLY, SWITH HAS A CORE ISSUE, I'M NO LONGER ABLE TO GRACEFULLY SWITCH DURING MIDNIGHT ROUTINES, SO ALWAYS CONCERNED THAT THE NEXT TIME THERE IS AN INI, THE SWITCH...

THANKS ALL, SO THE ONLY PROBLEM REMAINING NOW IS CC OR CLOCK PROBLEM. PRI LOOP 18 IS DOWN, SWAPPED PRI CARDS AND STILL DOWN. I ALSO HAVE MANY SLIPS ON ALL PRIS AND T1S WHEN I SSCK 1, I GET THE FOLLOWING DTI205 1 1 CHANGE CC FROM UNEQ TO 1 1 ? Y/N (N) I HAVE NOT ANSWERED YES, I'VE REVIEWED...

THANKS. GOT TAT FIGURED OUT ONLY ABOUT HALF OF THE LINES HAVE DIAL TONE, THE OTHER HALF CAN RECEIVE CALLS BUT NO DIAL TONE. DO YOU THINK IT IS A DTR PROBLEM?? FOUND THE DTR NOT WORKING DO YOU KNOW A GOOD PLACE TO PURCHASE OPOT 81C CARDS, I'VE EXHAUSTED ALL OF MY NT6D40AD CE POWER CARDS, WE...

HI. MERIDIAN OPTION 81C TOOK ALARMS FROM AN AT&T RACK FOR 12 HOURS (AT&T RACK HAD POWER ISSUES AND COULDN'T RECOVER UNTIL TECHS WORKED ON IT, FINE NOW) BUT NOW 2 COLUMNS DOWN, COLUMN 4 TRIPPED BREAKER AT BACK BY FANS. RESET AND POWER UP BUT CONTROLLER CARDS ARE FLASHING C 0 0 0 VICE THE...

OK I GET IT NOW,JUST TRACED AN ANALOG EXT IN THE SWRM, I SEE THE TTR, I WILL TRY IT TOMORROW ON SOME OF THE PROBLEM EXT. MOST EVEYONE HAS GONE FOR THE DAY. HOPE ALL I HAVE TO DO IS REPLACE A CARD THANKS AGAIN FOR YOUR TIME. HAVE A GOOD EVENING ------- 22 JUN 16 THANKS AGAIN, I HAD NEVER...

HI AGAIN, I DON'T HAVE DTR CARDS ON ALL THE SHELVES BUT I DO HAVE THEM (SORRY BRAIN DEAD EARLIER). IS THERE AN EASY WAY TO TEST EACH DTR CARD? THERE IS PROBABLY 4 IN QUESTION AT THIS POINT. THANKS AGAIN DTR CARDS VIA LD 32 ARE IDLE 4 0 15 8 1 15 36 0 15 68 0 15 TDS CARDS VIA LD 34 ARE IDLE...

IN MY CASE A TDS/CONF CARD. WHEN TRACED I GET THE FOLLOWING ACTIVE TN 004 0 10 06 ORIG 004 0 10 06 MARP 0 35774 500 TERM 008 0 09 00 0 SCR 0 35995 2616 DIAL DN 35995 MAIN PM EDSTD TALKSLOT ORIG 22 TERM 22 QUEU NONE CALL ID 0 6770 IS THERE A WAY TO TEST...

HI. I HAVE A MERIDIAN OPT 81C. FOR THE LAST TWO DAYS I HAVE ANALOG PHONES THAT THE DIAL TONE COMES AND GOES. YOU CAN DIAL THE EXT AND THE PHONE WILL RING AND CAN BE ANSWERED, HOWEVER AFTER THEY HANG UP AND THEN TRY AND MAKE A CALL THERE MAY OR MAY NOT BE A DIAL TONE. IF YOU DIAL THROUGH THE...

YEAH, I DIDN'T THINK I HAD TO REMOVE EVERYTHIG THE LAST TIME. OH WELL THEY'LL JUST HAVE TO WAIT ON ME. CUT IS TODAY I ABOUT AN HOUR OR SO!

thanks for the fast response appreciate the confirmation of what to do.

I'm chainging local carriers and need to change the IFC 5ESS TO NI2. If I DISABLE AND THEN remove the ADAN and TNs (LD 17, LD 14) associated to the loop and DCHs, will I be able to change the RDB or will i have to "out" it and then add it back (LD 16)? Trying to avoid a lot of reprogramming...