Search results for query: *

try making it a phantom 500 with the dcfw info set the same as the ncfw.

do you have any reports generated locally on the BCM? if you do, clearing out some of the older unused ones then starting stoppiing SRP will tend to clear out these issues for a while. UpdateHistory.txt is a culprit in most systems. it is built everytime the SRP is started and can get quite...

found the problem. i was programming on the tty. went to the server, and all is up and running now. thanks for the reply.

programmed a MCR on an 1140e phone and the phone did not display the line, and it give a re-order tone when called. reset the phone and the line appeared for about 5 seconds. the TNB shows the MCR. tried adding an active SCR from another set, the line only came on after a reset and then would go...

also, you might want to lock down the ports by going into the call pilot/configuration/system properties and changing the "max outcalling channels) to 0. the drawback to this is that you will be able to do outdial notification or even call a set to make recordings. but, if you are the...

if similar comes up, try disabling bus then re-enable. phones will take a little time, and the trunks longer. be patient. this has cleared out many of the events for me - one today on a 4x16.

most of the logevent247 messages will eventually get cleared out if you reload the DSM that the sets are terminateed on. i have seen the same errors coming from a group of BCM's that came out around 4 years ago. i have also seen the power supply going on the fritz in these BCM's and the...

sorry, fat finger on the first reply 167-170 for second half of GATM8

you can add trunks after the 4x16 is installed on bus 4 with your GATM 8 with offset 1 for bus 4 151-154 for 4x16 trunks 159-162 first half of GATM8 167-179 second half of GATM8

how are the outbound calls sent - PRI, LD T1, or POTS?

the description that the BCM gives for the bus and port does not make sense. Verify that attached sets/peripherals at Port <Fields 1-2> of Bus <Fields 7-8> initialize and function.If something is not working reset it.If the problem persists contact your local support group.Example :Logevent 247...