Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. dctechguy

    Registering ATA 187 on CCM 8.5.1

    Having issues getting a ATA187 to register. Keeps showing "Rejected". Licensing is not the issue. If it does register, whenever I make any changes to one of the ports and click "save" it then goes into Rejected state. Any suggestions?
  2. dctechguy

    CUCM 8.X PRI monitoring

    Thanks for all the input from everybody. I'm in and able to view.
  3. dctechguy

    CUCM 8.X PRI monitoring

    I was able to pull reports on incoming and outgoing etc. but I am looking for real time monitoring of the pri ports and seeing what is idle and active as calls are coming in and out. Am I missing something?
  4. dctechguy

    CUCM 8.X PRI monitoring

    Where do I go to monitor call traffic on my PRI circuits on the 2811 gateway? First, I would like to make sure traffic is flowing correctly between the two I have and I also would like to make sure the fail over is happening. Is this Possible with out contacting circuit vendor.
  5. dctechguy

    cisco 7961 won't boot up

    2 Options that have both worked for me: 1-unplug everything on phone - plug power brick into outlet and then phone whiling holding down the # key -When line buttons start flashing release # key -press 3491672850*# -wait a minute then unplug -plug phone back in to ethernet (and power brik...
  6. dctechguy

    Call Forwarding 2nd Line on 7940

    Working with CCM 6.1.3. Have primary line assigned to button 1 and an appearance of a line on button 2. Button 2 is a line that is assigned to an ATA. Is it possible to forward that line from the phone and not through CM User? I tried pressing the line button then softkey "CFWD ALL" and I get...
  7. dctechguy

    Trying to block 9.0 calling

    CM r6.1, I have set up a partition and a calling search space and then added in the Route Pattern 9.0 to have this pattern Blocked with "call rejected" and still can call 9,0 XXXXXX. What am I missing?
  8. dctechguy

    MOH for multiple callers on single device

    pndscm, thanks for info. I have been informed our vendor is coming in to take care of some other things on our CM so I will throw this issue at him while he is here. Thanks again!
  9. dctechguy

    MOH for multiple callers on single device

    We have set which Audio Source to use in the Clusterwide Parameters (Default Network & User MOH Audio Source ID) settings. Do you still need to mess with Media Resource Group & Lists? We are able to get MOH for the first call that is put on hold from a device, it's the second or third call from...
  10. dctechguy

    MOH for multiple callers on single device

    I'm maintaing CUCM R6. If I have multiple calls on hold on a single phone (single line), why is it only the first caller will hear the MOH? Is that right or am I missing something in the config or settings?

Part and Inventory Search

Back
Top