Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. scooter77

    A final question about backup, please.

    Try restoring the system from that card......if it fails , then you will know for sure
  2. scooter77

    On operator extension,why do outsid

    After the call is answered other operators can't pick up and transfer
  3. scooter77

    On operator extension,why do outsid

    On operator extension,why do outside calls ring in on system access buttons instead of assigned PRI lines that are programmed for immediate ring?
  4. scooter77

    AT&T Flex on Magix

    The invalid destination is set set to backup extension, however, I'm not utilizing DIDs. AT&T says they're sending 7 digits
  5. scooter77

    AT&T Flex on Magix

    I have a test number from AT&T and have the system programmed, which is working fine, except for incoming calls are getting a busy signal. Outbound works great. Any suggestions???
  6. scooter77

    Does anyone have a wiring diagram f

    Does anyone have a wiring diagram for a 355a adapter?
  7. scooter77

    Avaya 3920 Wireless Repeater Power adapter

    Yes ,as long as you know what voltage and amps it takes. You can utilize an RJ11 jack and jumper wire to connect to a compatible transformer.
  8. scooter77

    Dead partner 308 proc r1.0 model 103G

    As long as you're positive that the power outlet is working, then yes the processor is DOA and needs replaced
  9. scooter77

    magix 100dcd board installation

    What is the easiest way to install a 100dcd board? My system has all slots full, 3 cabinets. slot 4 has an old 408 analog board, which I can do away with. I recently replaced the analog 408 with the 100dcd board. I had to do a board renumber in order for the system to let me do any programming...
  10. scooter77

    Time

    I relocated a R 5.0 ACS. Since the move it will not keep the correct time. I've reset the time several times and have even backed up and restored the system ater correctng the time. It will keep the correct time for a while then it changes. Is there any fix for this?
  11. scooter77

    maintenance mode

    I don't have another 6 port as of this time, hoever, I did see light coming through the fiber. I had to put the 2 port back in so as to get the customer back in busness. Once i did that the system was fine. So, even if there is light coming from the 6 port card, could it still be bad?
  12. scooter77

    maintenance mode

    Yes, I added it at the same time. there was a 2 port card already in the system in slot 2, feeding the first two 0x16's, so I replaced it with a 6 port
  13. scooter77

    maintenance mode

    why does my 0x32 go into maintenance mode when i attempt to add a 016 module via 6 port fiber card?
  14. scooter77

    feedback eliminator

    will an avaya, FE-2HDA, feedback eliminator work with a nortel mics? if so, how do I wire it up?

Part and Inventory Search

Back
Top