Search results for query: *

will a kxdt 343 work on any version software for tda 100 or 200

usa..................

using the 1232 laptop software, i am trying to set up a ring group for the voice mail to send calls to 3 or 4 extensions if one is busy. have set stations in a separate ring group 293 i think, set that ring group to ring, and put that ring group into the voicemail to send callers too. but does...

have two NAM i upgraded both do the same thing after patch installed. both were working before patch but both 1999 mod and neither has a video card. have taken out hard drives and install in one that has video card in it. booth up pass the a booth then goes to c drive and continue to run. a...

trying to fix dn redirect. through the upgrade you sent me was to take a NAM 4.0 to a 4.1 to fix that issue. have 7.0 software, it see nam but cannot fwd to mailbox just back to AA. will this patch work on eailer release. have no way of knowing what it doing no video card in my 1999 nam...

just realized that the two NAM in question do not have a card in them for a mouse or monitor. both have RJ 45 in them. now what

Have updated a 4.0.04c NAM with the redirect DN software and the nam will not see the phone system. have done this on another NAM with same results. have a couple of floppy that have the same dir on them after i unzipped the download and have use one in the past to upgrade at least 4 NAM with...

yes i have saved it. will try next week to update. thanks for help.

this could be a problem, i assume i would need a floppy disk and do i power down the NAM and install the floppy and power back up the NAM? may be easiler to install a flash.............

have a fiber NAM behind a MICS. have never set up the auto attend but have use to transfer call into station mailboxes by voicemail transfer. set up auto attend and when it get to an station promp, dial the station number, it goes to that station rings 3 times and returns back to the auto...

I have been using the original Ver 4 software to program 816/1232 for 20 years went to use it last week and i get an error code of communication line disconnected. have ck my com port, changed cables, reloaded software, no luck. have downloaded the new windows software td1232 from the web...

have a cabinet with a pri and 6.1 software not being used. with the system off can i pull the software card out with out loss of any programming or the pri key code. need the 6.1 to upgrade a 5.0 to a 6.1 and then to a 7.1 . so what could happen if anything.

the only way that i know is a RAD and a serial cable with laptop. short of defaulting the system by shorting the capacitor. but you would have to reprogram the whole system.

any way to display name and number on a mics 6.1. while phone is ringing f811 would have to be done every time the phone rings to display number info?

totally agree but cannot find anything in programming guide or installation guide on what release started doing this.

have Panasonic set to go to the auto attendant on 4 rings but customer wants a night button or to put system in night mode by the code 780 and 781 if they leave early on some days. i put the system in the night mode but the voice mail will not play the 2nd recorded greeting which is the night...

Here is the simple question Does rel 2.2 do caller Id . I only can find rel 3 and 4 in a magic that does name and number Just trying to verify

No caller Id name or number

Yes

upgraded a merlin legend with 408 gs/ls id mlx and a magic processor cke5 2.2 v7.2. set the ls delay on the lines but no caller id. even have programed a button for caller id name. when into inventory and the 408 show glm-u. did not think i had to go with a older r7 to get caller id after...