Search results for query: *

Is Auto attendant standard on Call Pilot?

I realy cant remember if Auto Attendant is a standard package on Call Pilot?

Is it possible to count the number of times a specific number is called w/o using cdr?

Is there a way to light a indicator light on calls to an incalls key on a 2216?

We had a problem where then CLID would not pass until the call was answered and the problem ended up being a patch on the SS that wasn't suppose to be there.

Was this ever resolved? If so what was the resolution?

The phones are set to 100mbs

I should add that the program runs but it seems to loose packets or not run fast enough or something so that it fails to run properly.

Users use a program that won't run on there PC through the ethernet port on the set but if they bypass the phone and use the same switch port directly it runs fine. BCM 50 / 1140, 1210 and 1230 sets / problem software is Nova - Day One / using voice and data VLANs /

I read the downloaded info and followed the first example. This was routing the calls out over a branch using NRS and in the SPN I needed to set CLTP to NATL. It was at none and the calls were treated as UDP or CDP calls and always used the ext. #. Using element manager for making changes to...

I can't get the CLID table to send a specific #. I can get it to add the area and office code I need but it always uses the phone DN. These are going over a tie then out a PRI at the other location.We are trying to use ext. 6133 on the outbound ID instead of the DN. Everything works but we can't...

The 9 is coming from the Cisco and all works well now that it is built as a tie. When it was a DID it would not look at more than 4 digits because of the LDN0.

We changed the rt. from the Cisco to a tie rt. and it works.

Since the inbound calls from the Cisco are on a DID will the opt 81 look at more digits then what is defined by LDN0? Will it even look at the whole digit string to pass it on out the outbound circuit?

Below is the route and trunk info. Cisco rt TYPE RDB CUST 00 ROUT 20 DES Cisco TKTP DID NPID_TBL_NUM 0 SAT NO RCLS EXT DTRK YES DGTP PRI ISDN YES MODE PRA IFC S100 SBN NO PNI 00000 NCNA YES NCRD YES CHTY BCH ISAR NO CPUB OFF DAPC NO BCOT 0...

It is receiving the 9 and the number from the Cisco and the trunks are at NCOS 3 here also which should alow the calls.

It is a new setup. I will get some programming as soon as I can.

Yes, it goes to the pilot dn of VM and the NCOS is set high enough.

WE have a Cisco Call Manager sending calls (9xxxxxxx) to our Opt 81 rls 25.30 and want them to go out the local DID PRI. The calls hit the Opt 81 and go straight to VM. WE can see all the digits on the DCH coming from the Cisco. If you are on a trunk you can transfer a call out another trunk...

I hope someone can find the resolution. I have the same problem. Upgraded main site from 4.5 1000s to 5.5 1000E and message lites don't work anymore at the 4.5 1000s that uses SIP trunks for 4digit dialing and message lites. Everything works great but this. All patches are up to date on the far...