Hi
i have done a configure sip SIP trunk on S8300 CM 5.2 (signaling group and trunk group) without SES i have tested it with cisco call manager 6.1, it was working fine both ways but the same configuration if i route it to Alcatel OXO ( i am able to dial from the avaya to alcatel but one way...
Hi
I have done Qsig between CS1KE and Cisco it is working fine, I am looking for CS1K Qsig configuration with alcatel i want to compare it with the configuration i did for cisco. who did this setup before can you please send me the print of the route, D-channel and trunk.
thansk.
Hi
What is the different in the hardware and software between CS1000B and CS1000E in Rls 5.5.
Is the different in the MGC or in the SS,CS software.
thanks.
Hi
Is there an option to let the caller knows that called number is on another call (call waiting) like diffirent tone or message on the disblay.
thanks.
hi
i am able to make call but the problem i am not able to redirect the Ext. from the SRG to CS1000E.
i am getting this error on SS (04/02/2009 12:24:59 LOG0004 NCSSend: ncsMsgProcess : src=SRG DN not found: 211)
do you have the write steps to be configured on the SRG. i want to use SIP trunk...
I have SRG50 and CS1000E 5.0 integration, CS1000E has only SIP license. I have configured the CS100E as SIP end point on NRS and SRG50 as static SIP end point and H323 RAS. I want to make sure that what I have done is the write configuration or not.
I have registered the SRG50 on the NRS as...
hi
BCM networked with CS1K through H323 trunk,PRI trunk is connected to CS1K when i place a call to my mobile from the CS1K trhough the PRI it shows the directd number of the calling Ext. but if i dail from the BCM throug the PRI on the CS1K,i can see the BCM Ext. direct number on the IP and...
Hi
I have Unity with only unified messaging license no unity inbox license. I have configured a subscriber for one of the extension, if I am calling the extension I am not able to leave a message for the user, it is playing the default message for the admin mailbox.
Can I leave a message...
hi
these steps were mentioned in Nortel NTPS to change the payload value of RFC2833 for DTMF on SIP trunk to be compateple wiht CCM.
the problem if i cahnge it from the PDT by using setRFC2833 it will work but after i reboot the system it will go the default payload.
these steps as per...
no i am trying to locate the file startup and type command in the file but i don't know how how type the command in the file
this is wat i am trying to type
1 Locate the start up file named /p/startup
2 Type the following command the file at the end (where nnn = the
payload type value)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.