this is the configuration of the remote router i want to access :
Current configuration : 3750 bytes
!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname xxxxxxx
!
boot-start-marker
boot-end-marker
!
logging count...
You are wright ,
so this is the scenario
i have a local cisco 1841 router with ip 10.100.80.x/24
and my pc is connecting to this router .i want to access from this pc via internet explorer another remoter cisco 1841 router with ip 100.0.0.x/24 but when i type https://100.0.0.100 it shows me...
i am trying to connect remotely to a cisco router (100.0.0.x) through SDM application using internet explorer
i am typing https:// 100.0.0.x but i cant access it
my pc has an ip 10.100.80.x
can anyone tell me where is the problem??
the fact that my pc is in different network maybe?
i realized that when i enable "ip cef" command to the remote router my telnet connection is slow , also my ping command from the home router to the remote has not 100% reply and when i disable " ip cef" the telnet session is normal and the ping has 100 % reply...
can anyone explain this...
this is the configuration. the ip of email server belongs to 10.1.2.x network
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname xxxx
!
boot-start-marker
boot-end-marker
!
logging count
logging buffered 51200...
i have a cisco 1841 router in which i have enabled cef (cisco express forwarding )
i realized that i had network problems with other servers in the same network (for example the email server was too slow) . When i disabled cef these problems stopped
is there a relation between cef and the...
i have a cisco 1841 and i use hyper terminal for remote administration
The problem is that too slow when i am trying to configure it remotely.
can anyone help me ...?
here is my config.....
Current configuration : 4574 bytes
!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname ????
!
boot-start-marker
boot-end-marker
!
logging buffered 51200 warnings
enable password xxxxx
...
can anyone help with the follow problem ?
i have a cisco 1841 router and whenever i connect the ethernet cable to my switch all the pc's " behind" the router are failing over...
any explanation about this?
so, for example some ip routes for my hub site could be
ip route x.x.x.x 255.255.255.0 serial0.1
ip route y.y.y.y 255.255.255.0 serial0.2
is this correct?
hi , i have a cisco 1841 router...
i am trying to set it up so can accept many frame-relay point-to-point connections via a 2Mb line..
do i have to configure my serial interface with multiple subinterfaces?
can anyone help me?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.