Search results for query: *

Not a Fan of this new design

Can Twinning be setup to call out to two cell phones from one extension at the same time. So either cell phone can answer the call. We currently have this setup with ec500 in CM

If you buy a MM710B online and have Avaya maint. does this void your maint. contract or is just that card not supported

We do not have console just phones. So first we do a route-to ext xxxx. but if no one answers just keeps ringing as this extension does not have a voicemail box and we do not want to have callers leave one. Would like to be able to transfer then to another extension or group

Have a vector that routes to the Operator if you press 2. Problem is if the operator does not pick up the call keeps ring the extension. How can I change this so if call is not answered in like 15sec. goto a different extension.

Thank you, I did figure it out should of updated

I would make the 1200 a hunt group and have all the ext listed within

I am doing a ch trunk xx then on page one Service type from public-ntwrk to CBC

I am trying to change my service type on one of my circuits that currently is set for public-ntwrk to CBC. but am receiving "cbc" Must first change to CBC-compatible value and submit. What value and where?

you can do *3 to delete a message while listening to it.

I just forward the message to my corporate email address using the web client it comes in as a .wav file

Correct

in your 46xxsettings file change the following ############# ENHANCED LOCAL DIALING RULES ############### ## ## These settings affect certain dialing behaviors, such as ## dialing numbers from the incoming Call Log or from web ## pages ## ## Dialing Algorithm Status ## Controls whether...

Check to see if you have per button ring control set to on. If you do make sure you that the button for the appr. is set ring (r)

thanks will give it a try

Hi all, Looking to find a way to import a wav file that I have created to use as my greeting in my MM mailbox

Try disp st 0 see where it's cover path is set to. Then change the coverage path to the extension you want the call to terminate at.

You need to right click on the group tab then add the volume tab in choose table columns

i do this by creating a index pool of tapes.

I have been working a case with EMC on this issue. Part of the problem is when the system changes tapes it stops with the information from the first tape only.