Search results for query: *

Pounder222, AT the same point try RIP 000 or RIP 0000, I'm sorry I haven't worked on these for sometime. But if I remeber correctly RIP 000 should work. For switches 1000/1100 - same method switches 3300/hub 24 etc - 3comcso RIP000 switc 9300/3900 - admin/lanplex Hope it helps.

All, To default the 3500 log on as you do and type sys nv reset if you do not know the console login try: admin/lanplex else boot via the network and then erase the psswd: Solution ID: 2.0.5630895.2322051 - 3com solution to boot because of corrupted s/w: Solution ID: 112.0.358638.1515824...

You will find that 3comcso/RIP000 works on: 1100 3300 s2/s3 ps hubs on 1000/3000 uploading a s/w does not erase the psswd u follow the procedure set out by djones dljones (IS/IT--Manageme) May 24, 2003 An if that don't work you can reload or update your firmware to reset the passwords, you...

try admin lanplex this psswd works for most corebuilders or recover/recover hope it helps

Hi, Try to download the windows serial update utility from the 3com site. You'll find it from the knowledgebase by asking questions about the 3300 - won't boot up (sorry don't have link to site for you). Also download v2.69. Install the utility program and load the s/w. Hopefully you'll get...

Hi, open the switch up and you will find two electrolytic capacitors have blown their tops. Replace with 2200uf 16v. Problem solved.

Try recover recover or admin lanplex

To access the console set your terminal emulation program to: 9600,n,8,1 using either 3com/cisco/null modem connector to the console hit enter several times You will see login prompt enter: security security 3comcso RIP000 should reset hub to default.

Cloonie, Try admin lanplex

Hi, To default the ssii 9300 try: admin lanplex then follow what it says on your terminal

You will find the lanplex 2500 will only work with the 3c509b card not any other pcmcia version card - it has to be B. Can you press l in the above mode and do list of all boot vectors - and go from there. If you don't have the 'earthquake recovery' pcmcia or the 3c509b pcmcia card you can't do...

TRY admin - user lanplex - psswd then hard reboot within 30secs

topoh, Can you be more specific, describe the exact steps you did.

Hi, The switch 1100 will only give you 100M on ports 25/26, the rest are 10M. If you're able to upgrade to the 3300

Connect via the console port, hold down the space bar and power up. This gives you a boot rom menu. Type ? or help for options.

This unit is a 12 port 10Base T hub. For management you need a Y16630 which slots in the back.

Hi, To input changes you have to be netmanager. you type se priv=net then asks fior psswd ~I assume you don't know the psswd, therefore: boot up the router or if already booted using a non conductive pin press the switch(located on left hand side, you'll see a round hole. This gives you access...

upgrade to 2.69 using serial update program both available from 3Com site. This fixes all the leds on scenario.

Hi, Do all the leds stay lit when first turned on, without nothing connected? reload the software 2.69 using the serial update program both available form 3com. Else you have loop. But I say its the first scenario.

Get the latest version for windows 98/me/nt - works a treat at the 3Com site.