Search results for query: *

I reloaded last nights backup but still get a fast busy when I use this route.

The buttset is set to "T". Changing it to DTN stopped the pulse generator from starting but I still have about 15 seconds of silence before I get a fast busy signal. I changed the DN's to CLS=DTN in LD 14 and some other things in Ld 16 to make this route the same as another but did...

Yes, I can dial out with a butt set. These lines are also working as a incoming lines.

all idle

Yes, it was DIP, changed it to DTN, but I get fast busy when dialing out.

I have a route that is pulse dialing and I want to change it to tone dialing. Where in LD 16 do I make it happen? I made all the RDB parameters the same as another COT route but it still uses the pulse generator. Do I need to re-boot the system? Thanks for any help.

That all worked fine. Outgoing calls are on route 3 when tgar = 2. Thanks for all the help

Does the Magix system have the ability to do secretarial filtering? Or the ability to separate extensions so that all internal calls must go through another phone before they connect to the final extension?

Thank you for replying to this thread. When I printed the RLB I did not see route 2 listed on any entries. I see the 2 routes (6 and 9)that work on many different entries, but not sure what it all means. I'm guessing that the addition of route 3 is not a change but a NEW? What other info will...

I tried route 3 not having tgar 2 also other values. where do I set the FRL to allow NCOS?

where do I enable a trunk and it's members to be used for outgoing calls? I can receive calls on them but not call out on them. Eventually I will want a group of extentions to call out on this route.

The TARG/TGAR barring is setup on my switch and works for 2 of the companies sharing the switch (tgar 1 = route 6: tgar 3 = route 1), but I'm having trouble with tgar 2 = route 3. I can get my phone to change between the 2 routes with the TGAR value and check it with call accounting software...

The TARG/TGAR barring is setup on my switch and works for 2 of the companies sharing the switch, but I'm having trouble with the third. I can get my phone to change between the 2 routes with the TGAR value and check it with call accounting software. I have followed the info in this thread but...

When our operator is at lunch, all incoming calls need to be forwarded to another phone. Is this setup at the console or in software? Can separate trunks and their members be forwarded to different phones?

I have 3 companies sharing my meridian, company "c" calls are going out on company "a" lines. How do I re-route their outgoing calls to go out on their own lines? Where do I print this info and where do I change it?

if I change my SPRE code to 88, will this allow me to use the 800s for extensions except for 880 thru 889? when changing the customer data block in LD 15, do you just hit <cr> until you get to the item that you want to change or do you have to enter all the items in as you see them?

does TYPE SFP have anythiong to do with SPRE code of 8?

TYPE SFP

How do you allow or configure a meridian1 option 11c release 17 to allow dns 800 thru 899 to be usable? The system won't allow me to change key 00 to this range of numbers. There are plenty of available TNs. There are no currently setup 800 or 900 extentions, just 100 thru 799.

found the problem, thanks for the help the system was built with a pretranslation (XLST) level to prevent internal callers from accessing the 100's