Search results for query: *

I have noticed that if pass code for conferencing has number 8 it does not work. for some reason number 8 does not generate the tone. any help will be appreciated.

I have a CISCO call manager express for one of our site. the problem we are encountering is that when they make outside calls, the caller id just show their last 4 digits of their number rather than 10 digits. anyone knows how to set the system up to show the 10 digits. Thanks.

Muting did not work.

Thank you both for the information. I haven't done neither of them yet. I'll try and let you know.

my users have problem when they try to join conference calls using their Nortel phones. they enter the pass code using their Nortel phones to participate but it gives them error. they use their cell phone without any problem. dose anyone have any solution or encounter this problem. please...

there is no SAR group number defined.

greetings.... i have a T1 tie trunk from nortel 81C to cisco call manager with unity express. after 11pm any calls to any numbers on CISCO bunce to call pilot and does not go over to cisco. would you please help me to find out why is that? Thanks in advance.

Thank you everyone. it is working now.

you are great. thak you for taking time to respond to my questions. yes, it is 81c and I bought this card and the vendor installed it. Nortel Merdian Duel PR1 Module (NT5D12AB) The vendor did not tell me anything about daughter board.

would you please give me the command and how to do it if it is not extensive procedure. Thank you.

sorry wrong message DTA015 18 !err dta015 > > DTA0015 loop Frame slip-tracking-maintenance limit. Severity: Critical

Greetings... Please let me know how to get rid of this err. Thank you in advance DTA015 18 !err dta015 18 > > OVL441 Help text not found for error code: DTA1518

i am sorry, i am not at the site, but i think the vendor define it wrong. I think it should be a PRI TRK and not a DTI. we have a tie trunk to option 11C which is working fine. I think this should be the same. please see the definition for the CISCO. DTI TRK LOOP 60 - ENBL FFMT/LCMT/YALMT...

greetings.... I have a vendor install duel T1 card and defined the tie trunk on that T1. for some reason the ALARM STATUS is RED and it does not communicate for our CISCO phone system. Please help. Thanks.

thank you so much.

thank you for quick response. i did stat and prt and i get these. please tell me the commands. Thanks. stat 8 SUPER LOOP CARR CALS TTSA NND SPARED? 0 3 0 /21 YES N/A 1 3 0 /21 YES N/A 2 3 0 /21 YES N/A REQ prt TYPE supl SUPL 8 SUPL SUPT SLOT XPEC0 XPEC1...

greetings... would you please tell me how can i enable the supperloop. my remote cabinet in 81C went down, it came backup but is down and i need to enable it. i know it is look 32. Thank you in advance.

thank you. i found it and made the change. it is working. thanks again.

where is this entry?

thank you both. right now what shows is the DID number followed by 0000000s. like 607100000000 to outside rather than area code and the number.