Search results for query: *

Thanks Rick, I rebooted like you said last night and the problem seems to be gone. For how long, I guess we'll find out, but at least I know what to do if that starts happening again.

Our office uses a BCM400 fully patched etc. Lately we have been getting alot of alarm 63 on our T1. We are the local telephone exchange and I have made sure the T1 settings match etc. Has anyone had experience dealing with this alarm? The problem is randon on different channels on the T1...

3300 with Auto attendant answering main incoming trunk. 4 digit extensions. when someone enters a 3 digit extension the system attempts to transfer to the extension and then the message " that mailbox is full and cannot accept any new messges" plays. where is the call being routed to? how...

http://www142.nortelnetworks.com/techdocs/BCM25_FP1_OD/pdf/NZMT4DHN.pdf

Here's the deal. Removing DN's from CAP list in Global settings did the trick. i also removed the hunt group appearances from the kem's. now they are good to go. unfortunately the only way to remove the affected DN's was to enter in another DN on the system. anyone got any better ways to get...

Tried that too Dewey.... still not allowing me to remove DN from list in Element Manager. the only way to get a particular DN off this list is to switch it with another DN, but then I have the wrong DN in the list instead. Very frustrating!!

Tried your suggestion Dewey. These are IP sets that I'm attempting to remove from list. Unplugging the set and then removing from list didn't work either. Element Manager wants something in the list in place of DN and I don't know what?

Sorry, I might have been to vague in question. I was talking about in Element Manager, when you try to remove an assigned DN from the list of CAP's I'm not sure how to do it Thanks

Trying to deprogram CAP in BCM400. What is the key to doing this. everytime I try to clear the existing DN to None it tells me that it is invalid. I've tried to enter "None", DN*, Nothing at all, none of these are working. Any thoughts?

Thanks guys and gals... I have two hunt groups assigned to the KEMs. I'll move them off the Kems and see if that makes a difference.

BCM 400 4.0 fully patched. Still having issues with attaching KEM to 1140e. Kem's are basically blank and then the set itself locks up. Anyone experiencing the same issues, if so is there a cure yet?

Recently installed a MICS 7.0 with a Call Pilot 150. Customer is complaining that message notification is delayed periodiacally. Anyone have any suggestions or know the reasoning that this might be happening.

Recently installed a MICS 7.0 with a Call Pilot 150. Customer is complaining that message notification is delayed periodiacally. Anyone have any suggestions or know the reasoning that this might be happening.