If I disable the wan port and plug into the cable modem,
I get whole different IP address. What am I doing wrong.
The books aren't clear on getting this to work.
I am still having problems getting this to work.
So I am just going to use cable moden right to the IP Office.
I am using the crossover lan cable to the wan port and my cable modem IP Adress is 72.141.197.36
sub net mask 255.255.255.128
default IP 72.141.197.1...
I don't get anything when I go from the Cable modem to the IPO. Do I need a crossover cable with that setup. I did see
the IP address show up in lan2 with the cable modem's address.
I think I am missing something in the internet service tab.
Here is what I have, A cable modem going to a router. The router work good, The default address is 192.168.0.1
The DHCP address's on the router start at 192.168.0.100 to 200. The router is setup as auto detect.
Now I want to go from the router to the IPO, I have disabled the lan 2 and plugged...
I've tried just about everything to get this to work and no luck.
Can someone tell me what steps in programming need to be done to get internet access working.
I did enable lan 1 as server, but the mistake I made, was putting the router address 192.168.0.1 in the primary address of Lan 1 and Lan 2.
I did try the cross over cable on the wan port and using the address 192.168.0.107 on my PC and 192.168.0.106 on lan2
the default gateway is 192.168.0.1...
I've tried getting back in through remote IP address, but no success. I used 192.168.99.0
I tried use the DTE port, but when I type int the ATX command all I get is OK.
What am I doing wrong?
I set it up, But soon as it reboot it never came back,
nor did the phones. Now I can't get back into the system at all. Is there a way to get back in remotely.
I went into Lan2 and clicked on Nat and client.
When I try to put in the IP address and subnet mask and
click ok, It disappeers and won't program.
The setup I have is, the cable modem to a router and from the router to the IP Office.
HI all
I have a SOE with 3.2.55 and a cable modem. I plug the RJ45 from the cable modem to the wan port on the SOE.
I plug a lap top into any set and I do not get the internet.
Is there anything I have to program for internet access.
Hey aarenot thanks for the info for IP Office link.
I load the system with 3.2.54, but I have a couple of issuses.
When I do a change to an analog port, it only lets me do one change and I have to save it to the system before I can do another change.
When I use monitor, it goes though all the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.