Search results for query: *

Yes, keyword - "Client Termination", you can find it in webGUI under VPN settings. -------------------------- I'm from Russia...

Please note, that BSR 222 drop IPSec VPN after 2 minutes, if there is no incoming traffic in this tunnel. You may try to check Nailed-Up on VPN page in BSR: if tunnel goes down it will try to restore automatically in less than second. -------------------------- I'm from Russia...

Enable Disconnection Supervisor on analog trunks on bcm A. This will help. -------------------------- I'm from Russia...

This is because BCM does not support SIP dynamic registration? only static. -------------------------- I'm from Russia...

Technical Documentation is available on Nortel website. As for me, there is nothing new, except increased capacity. -------------------------- I'm from Russia...

2 lliesbthighs: You need to create a static entry on NRS for BCM. On BCM you need to fill IP trunk settings only for SIP!!! at the proxy IP you need to write IP address of the Node on SS. Next you must fill SIP URI (as you create URI on SS) and set codecs. After that - some routing entries and...

BCM NOT support dynamical registration on NRS when using SIP. Only static configuration. Also you need to set UDP as transport on NRS, beacuse BCM don't support TCP. There is no way to ensure that BCM properly registered on NRS. The only way to check it - try to make call...

This is limitation for all Linux Release BCM (all bcm50 and bcm200/400/1000 rel.4). You need special account called "nnsupport" and get password of the day from Nortel. -------------------------- I'm from Russia...

What IP settings do you use for clients? Static or DHCP? If dhcp try to look at dhcp aging time. -------------------------- I'm from Russia...

Try to run ccrstest.htm and check the real status of history reports. Maybe you need just try to stop/start RCClauncher. -------------------------- I'm from Russia...

Hi, had similar problem time ago, we did open case with Nortel. The solution was found in defective stack cables, try to check your cables: Cable quality defects were found in one particular cable vendor. These cables have been identified as being manufactured and shipped from the beginning...