Customer has analog trunks on a MICS. Currently trunks appear and ring only on a couple of phones, flash vmail answers after 2 rings.
After 5pm, when office staff leaves, the owner thinks he should have the ability to direct all incoming calls to his phone with a button.
Lines only appear on...
Some of my 9508s will go dark, some will not. I need them all to go dark, the Auto return is set to 60 seconds. Doesn't seem to make a difference. R11 system, essential.
You can shut it off and swap the cards yes and no programming needed. there is always a chance of losing programming but I would say you have little choice.
...start with no prefix. Connected quickly. On the new IP 500V2 A, trunk is also loop start. I added prefix but found it worked a little faster (seemingly) using a Dial short code and dialing *. Still takes about 2 seconds for the phone to show 'Connected' so maybe that is the await dial tone...
I have two identical Partner R6 308 processors. Both have SOE written at the end of the part number on the sticker. One will work with a 5 slot and a 308EC, the other will turn off the 308EC every time. Doesn't make sense to me.
...on a trunk port. Line appearance on all phones. Paging worked immediately. Now on 406ATM on IP 500V2A, there is a delay. I put in a short code *60 to line group 10 and dial * to get the unit to respond. We still wait about 2 seconds then see Connected on the phone display then paging...
You know I put in the user group short code 91N Line Group 1 and I think I was sending an extra 1 to the telco causing an error message. Was that my problem? I think so. I do not have two different ARS tables. I will have to try again Monday.
Customer has R11, analog trunks, in standard mode, we dial 9 for an outside line. I need a select group of extension when they dial nine to go out line pool 1, rather than line pool 0. Can/should that be done from user groups/short code? What would you recommend?
Well here in the office with 2-3 phones it works ok, at the customer with 15 -16 (20 req'd) phones it will not work. it resets, locks up and basically shuts off. A similar equipped 2100 works just fine. even with no trunks and no lan attached, it's useless.
If I swap out the power supply is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.