Search results for query: *

The drive should be at least the same size, if bigger only the size of the primary will be used on secondary, e.g. primary 40 GB, secondary 60 GB - the partition created by the raid-controller on the secondary will be 40 GB, so 20 GB will be unused. It is recommended to have the same RPMs for...

Thanks for the answers (would be PRI). Gonna give the analog loop a go Thanks again.

Hi again, after we got the VMs working our next step was to set up a test with AA. As you already should've gathered from the Subject line, the BCM 50 ist not connected to any live lines yet, so we are working with 4 digital and 4 IP sets on location. 1. Is possible to test AA without live...

Did a reboot and when it wasn't working, deleted VMs another reboot and set up VMs again. Don't ask me why but it's working. Still on Rls 2 and I have to check those core patches but we will update to 3 soon anyway.

Thanks, just figured it out with the guys here. Good stuff!

Ok, 774 is the General Mailbox. Ok, here are the steps I am going through the following steps: 1. Going into CallPilot, set up a VM, eg. for DN 761 Mailbox No.: 770 Extension: 770 (Am I right to take an Application DN for VM - as VM is an application?) 2. In EM under: Telephony>Sets>Active...

Ok, now F985 brings up VM 774. I never set that one up anywhere. Have to have a look into that. If any more ideas just keep me posted. Thanks.

@cook1082: Yep, 3 mailboxes have been set up, two subscriber and 1 info mailbox.

Hm, it brings up: CDN 1: None CDN 2: None Vmail works as far as you can can check it and compose message and send them to other mailboxes.

Just set up an information VM - can't even dial into that one (758). Seems like EM "can't see" CallPilot.

Yep, found that one, call forwarding works fine (tested it with another set 761 > 762 >758), but the VMs are not kicking in - keeps ringing.

THanks for your replies. I'm In EM under Config>Telephony>Active Sets>Cpabilities&Prefs - but can't find anything on Call Forward No Answer.

Hi, just trying to figure out if it is possible to have Voicemails internally with BCM50. E.g. me (761) calling 762 - na answer and after 5 rings should go to 762's VM. Not happening at the moment, 762's VM is activated though.

Hi guys, sitting here having the BCM50 set up all in theory but struggeling with the wiring itself ... we got some advise on how to wire it but honestly I think it was a whole lot of BS. Don't know much about telephony but are expected to set it up. Got a Meridian here going into an Eircom...

Alright, thanks for the quick replies.

HOW COULD IT WORK?" That's what I'm asking! ;)

Hi guys, I know Nortel restricts us to use certain Nortel sets with the BCM units. But is there any way to set up a Cisco phone (7960 series) with it? Rainman

Which Codec are you using? Which payload size? (before playing with the settings, take a note of the used setting as QoS might drop.)

Go to START > RUN > type CMD > OK Now try to ping, type: via OAM: ping 10.10.11.1 via LAN port 1: 192.168.1.2 Then check the IP settings for your PC: START > RUN > type CMD > OK type: ipconfig

Hi, Check if the DHCP-server is enabled - if DHCP-server on BCM used check: Configuration > Data Services > DHCP Server Start the BCM Monitor and go into IP devices - anything there?