Search results for query: *

Having issues getting a ATA187 to register. Keeps showing "Rejected". Licensing is not the issue. If it does register, whenever I make any changes to one of the ports and click "save" it then goes into Rejected state. Any suggestions?

Thanks for all the input from everybody. I'm in and able to view.

I was able to pull reports on incoming and outgoing etc. but I am looking for real time monitoring of the pri ports and seeing what is idle and active as calls are coming in and out. Am I missing something?

Where do I go to monitor call traffic on my PRI circuits on the 2811 gateway? First, I would like to make sure traffic is flowing correctly between the two I have and I also would like to make sure the fail over is happening. Is this Possible with out contacting circuit vendor.

2 Options that have both worked for me: 1-unplug everything on phone - plug power brick into outlet and then phone whiling holding down the # key -When line buttons start flashing release # key -press 3491672850*# -wait a minute then unplug -plug phone back in to ethernet (and power brik...

Working with CCM 6.1.3. Have primary line assigned to button 1 and an appearance of a line on button 2. Button 2 is a line that is assigned to an ATA. Is it possible to forward that line from the phone and not through CM User? I tried pressing the line button then softkey "CFWD ALL" and I get...

CM r6.1, I have set up a partition and a calling search space and then added in the Route Pattern 9.0 to have this pattern Blocked with "call rejected" and still can call 9,0 XXXXXX. What am I missing?

pndscm, thanks for info. I have been informed our vendor is coming in to take care of some other things on our CM so I will throw this issue at him while he is here. Thanks again!

We have set which Audio Source to use in the Clusterwide Parameters (Default Network & User MOH Audio Source ID) settings. Do you still need to mess with Media Resource Group & Lists? We are able to get MOH for the first call that is put on hold from a device, it's the second or third call from...

I'm maintaing CUCM R6. If I have multiple calls on hold on a single phone (single line), why is it only the first caller will hear the MOH? Is that right or am I missing something in the config or settings?