Search results for query: *

suggest to check setting DORG prompt in RLI set to YES

Is it a TIE or a DID ? If am right only TIE's would pass on the names. Would be better if you can explain the setup in more detail.

I guess what you want is a call pickup group. There is both Directed pickup or group pickup. In simple the steps are, Create RNPG in the phones TNB with CLS PUA. Configure key RNP. Then toggle with DPUA, GPUA. Configure FFC's PUGR and PUGN accordingly.

Hi Rufen, Not sure if this might help you. check LOUT in the PWD data block. LOUT 1-(20)-1440 Logout, Inactive Session Logout Time in minutes

Check if you have TRO enabled in the route between Remote site and Main office. If so Disable TRO in RDB and check

What is your CS release ? And your CP release and SU ?

It is a general recommendation to patch through the Patching Manager. But i do it through the CLI everytime. There was an issue with CLI as curtismo said. Not sure if you can view the below https://kb.avaya.com/ext/index?page=content&id=SOLN154358&group=UG_INTERNAL

If a USB is created as a bootable Compact Flash by mistake and com1 install is used on a CP DC or CP MG, and the error message appears on the COM port console.

What about the Stat of TTY ports. Ld 37> Stat TTY. Trying disabling and enabling it. Do a dummy/blank change to the ADAN TTY data for that particular TTY.

yes you may have to open a ticket with Avaya i guess. Or if you have an Avaya SSO login ID, may be you can try chatting with someone on their Live Agents on Chat, look at their support websites right top corner.

Guess , you can ssh to the MC32 card IP if that is possible. OAM> Ctrl+pdt PDT> 'rdopen' 'rdall' .

Can you check , if the CS is able to ping the Primary Security server from LD 117. ?

In the CFN .. Ld 17 CHG CEQU

The Application Server for the Personal Directory, Callers List, and Redial List features (IP Phones Application Server) runs on the Signaling Server. The Callers List and Redial List are call log features. 1.) enable Personal Directory service in "Node configuration" interface in Element...

XFA only for analog phones i guess

Check XFA, for allowing transfers. FTTU and UNR already there. And also Tromboning , TRMB is yes, as said above. If its failing, you can do an entc and check and/or dch messages.

It may be patch mplr 32276

Try this 1) Reboot the PC and log in using the local admin account. Do not attempt to log into OTM. 2) Start --> Programs --> Administrative Tools --> Component Services 3) From Component Services expand the following folders --> Computers --> My Computer --> COM+ Applications 4) Right...

May be a problem with the DRAM2. Check if you can reset the 1X75 card to try clear the alarm

Have a look at these patches too 24840, 24941 and 25073