Hi Guys,
I hope you are ok.
I am trying to check if my PBX has enable the future trunk to trunk transfer I only have only one circuit TIE in which I want to receive a call and after thtat transfer it in throught the same circuit to another party outside. What do i must to check to confrim that my configuration is ok to permit trunk to trunk transfers
this is my configuration
TYPE NET_DATA
CUST 00
OPT RTA
AC2
FNP YES
ISDN YES
PNI 1
PINX_DN
HNPA 214
HNXX
HLOC
LSC
RCNT 5
OCLI NO
TRNX YES
EXTT YES
FTOP FRES
VNR NO
NIT 8
FOPT 14
I hope you are ok.
I am trying to check if my PBX has enable the future trunk to trunk transfer I only have only one circuit TIE in which I want to receive a call and after thtat transfer it in throught the same circuit to another party outside. What do i must to check to confrim that my configuration is ok to permit trunk to trunk transfers
this is my configuration
TYPE NET_DATA
CUST 00
OPT RTA
AC2
FNP YES
ISDN YES
PNI 1
PINX_DN
HNPA 214
HNXX
HLOC
LSC
RCNT 5
OCLI NO
TRNX YES
EXTT YES
FTOP FRES
VNR NO
NIT 8
FOPT 14