Search results for query: *

It's difficult to envision what you are trying to accomplish but it sounds like a hunt group/hunt pilot configuration may work better. You can configure hunt pilot/groups in LD 18, I think. It's been a while.

AvayaHE finished where I was going. You need to build a QSIG dchannel in the Seimens.

So you're using QSIG trunks for a SIP endpoint/interface?

First trace one of the tns that is hard forwarded to VM. Make sure you see CFW activated. Then change the CLS of the phone to cfxa. Has your VM pilot dn always been a steering code?

From a good port enter tty x to test the suspect port.

I would put a laptop on it and send a test to it from another working tty. Just make sure that the baud/parity/bits is set correctly. If it's a qsdi card and depending on your release I think it has to be a D vintage. If it's an msdl pack I suspect your just seeing the dch port trying to...

Looks like it's downloading the database as a dch. I've never had to download for an SDI device like a teleboss. Have you pulled the card to check all of the switches? What is it an nt8d60?

So you're all set? I've seen FLEN work both ways. Sometimes you have to tell the far end how many digits you're sending and other times you can't tell it.

We use SIP to the PSTN here. 10K DIDs and 350 CCPs. Two trunks inbound one is DR. We've not had any problem with our provider. They do T.38 but to me the real key is the codec. We made sure that only g711 is used. ATT however does suck. As for us being a dying breed, I agree with that but...

Have you checked layer one? Take the phone to the switchport and test it there first.

And try one other thing just to humor me. Change the FLEN to 0.

So maybe try this for a work around. Build a phantom tn with the incoming dn. Set a dcfw to a dsc pointed to the asterisk pri. PITA but if it allows you to pass calls who cares right?

If it rings through to a Nortel phone then they are sending four. If you don't have to input anything for TEN when building a phone then you aren't using tenant service. I would involve your vendor at this point. Make then escalate to TAC.

I would turn on DCH messaging on the 81 and watch what you are sending across the tie route. Build a test RLI and send one NPA across it. If you guys are still able to dial seven digits then do the same for an RLI to test an nxx with. I would also suggest that the guys who are working on the...

Ok kinda forget where we are but can you try this? The dn that you are trying to pass to Asterisk, can you put that on a set on the CS1000? If you can and it terminates on the set you program it on that will confirm what and how many digits they are sending on the LD route. I hate beating...

I don't think they are sending 4. These numbers are internal only or are they DID? If the are DID I would go ahead and build an IDC for the whole ten and seven digit number xlating to the DSC. Assign that to route and see if it helps. I never trust ATT.

I'm ordering a Valcom 2000A. Thanks everyone.

How are the incoming calls arriving? Are they the exact dns as built in CDP or are they sending 7 or 10 digits? If they aren't the dns you have defined you will need an IDC table or change the dsc to match. Sounds like the switch isn't even attempting to signal the DCH.

No we do not. But I will today if I can't make this work.

Have you been administrator for this switch a while? Do you know if you guys use tenant service or have tbar set up? Both could affect trunk to trunk connections. What about TRNX and EXTT in NET_DATA. I've seen those settings cause issues with trunk to trunk connections. Even if the local...