Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Paging Migration-CS1000 to CUCM

Status
Not open for further replies.

RickyPone

Technical User
Apr 22, 2011
509
US
So the current config is a universal trunk in the CS1000 to a standard 600ohm input. Not sure of the amp brand, but it is an audio amp, ie. Yamaha. Signal is then sent, amplified to speakers. Trying to get an FXO port to work with the same downstream set up. I can dial the route pattern, FXO goes offhook, and then disconnects. The FXO is looking for voltage I assume which won't be provided by the amp so the connection is dropped. Has anyone successfully tuned an FXO port to work without applied voltage? I looked through the voice-port settings but nothing seems appropriate.
 
You dont have any type of controller in between? IE: Bogen, or Valcom?

Certifications:
A+
Network+
CCENT
CCNA Voice
TVOICE
CAPPS
CIPTV1
CIPTV2
 
No we do not. But I will today if I can't make this work.
 
I have never had any success getting paging to work without one.

Certifications:
A+
Network+
CCENT
CCNA Voice
TVOICE
CAPPS
CIPTV1
CIPTV2
 
An FXO port will not work if you need a 600ohm output. You can do it with an E&M port however. If you don't have that then you can put a device like a bogen tam-b between the fxo port and the amp.
 
I'm ordering a Valcom 2000A. Thanks everyone.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top