Search results for query: *

Thanks for your replies. Yes it appears below v5.0Gs the meta file MUST be used. I think this thread can now be closed. Cheers “Patience, n. A minor form of dispair, disguised as a virtue.”

I have recently been upgrading customers Ipecs (MFIM 50 A and B type) who are using version 5.0 to v6.0 (version 6.0Cv is the latest I have). Now to get to this stage you need to go from version 5.0 then v5.5 then v6.0. However, there seems to be some discrepancy on how this is done, I have...

Transpgm - yes you do have an extremely ancient version of ipecs. I believe s/w V2 was circa 2003. There have been a few major updates since then. Ipecs is now on version 6.0Cv. I'm not 100% sure but your hardware may not be compatible with the latest s/w. Is there anymore info in the left hand...

I am having an issue trying to failover from the auto attendant to hunt group 461 (HG01) during the day. However I have had to create a messy workaround via the main DDI number. In the AA message the caller must dial 0 to get to the main attendant ext 221. I have then created a forward to...

I dont know if you have already checked this out. It gives you an idea how to get the solution I think you are looking for: http://support.microsoft.com/kb/135268 Hope this helps in some way “Patience, n. A minor form of dispair, disguised as a virtue.”

Hi Simon, It sounds like you are on version 3 of the Nexer CCU. Just to start you off try Trans/Pgm 72 on any phone this will give you the ip address of the system. Sometimes you need to change the network port as they can fail. Also if you do get to the web admin software it isnt guaranteed...

Thanks for the replies guys. “Patience, n. A minor form of dispair, disguised as a virtue.”

Ipecs 5.5 now requires you to enter https://10.10.10.2 by default to get into system. My question is this - how do you turn this feature off ie, using http://... I have located the web server port 443 in PGM 160 but cannot find how to turn this off. I assume it must be possible as I have...

Thanks for all the help help guys. I set the mail address in board based data PGM 132 and that did the trick! Apologies for late reply Kind Regards Stu “Patience, n. A minor form of dispair, disguised as a virtue.”

Your Welcome Doktor!!!

Hi Doktor, The S/W version is 5.0GS. Thanks for the above information. I will be looking at the setup and I will be trying your suggestions tomorrow and will report back. Regards,

Hello there There was an issue with LCR and older versions doing what you mentioned in your post (i have found this out through personal experience). Try upgrading your software to 5.0GS and I believe your problems will go away. Regards, Stu

Hi All, I am trying to set up VM to Email and having no luck. I have used PGM 111-113 buttons 54 and 55 respectively and entered: VSF MSG - SMTP Mail Server Address: mail.example.com VSF MSG - User Mail Address: person@example.com...