Search results for query: *

Thanks Brian and Skip for the info... I will give that a try tomorrow...

For the upgrade to R7, Does anyone know approx. how much it will cost and a good source to purchase it through? Also, I assume the procedure for the upgrade is like the ACS upgrades? insert the PCMCIA card, power on, wait for the signal, power down... with programming preserved?? (and a...

NB... I had this same problem with an ACS 3.0 and a VS 5.0 about six months ago. The same was true... you were not able to record any messages - Patty Partner told you that "your message is too short" whenever you tried to record something. In my case, the customer's 2 slot carrier had a...

OK, I know that below release 3.0, the power supplies tend to run very hot and pop like corn... That being said, I have a customer unit that "hisses" when you power it up. (I am thinking a transformer or a coil, possibly a diode or a transistor is gone??) The unit powers up properly, the...

THANKS Sky... I will give it a shot this afternoon.

OK guys.. I so need help on this, I am drawing a blank! I have my laptop hooked up to a customers Partner Mail Unit (release 1.8) - Connected to it via my terminal app, logged into the system and have the main menu...but I cannot remember for the life of me how to initiate a factory reset or...

Hi! I have the same problem... an "orphan" radio module and a 9031 I want to rematch... anyone know how to do this??

See the 'CA 48 on a Partner system' thread688-832772 message... TouchToneTommy answered this question there... THANKS!!

Tommy... You did answer it there... I posted both of these at the same time.. (well, almost the same time!) THANKS AGAIN for your help!!

I know this is an old post... but I just read it and it is close to the problem I have, but I don't have the damn adapter... What pair do you wire it to?? I have the original cables from AT&T/Lucent... out of the power supply, the cable I have (with the blue keyed connector) the power is on...

Hi! I have a client with a CA48 Intercom Dialer. Someone 'needed' the adapter (the 304B splitter that injects the 48v DC that powers the unit) and they took it... Does anyone know what the pinout for this splitter/adapter is?? If not, does anyone know where to get one?? (or if I even have...