Recent content by yeahbutno

FYI This was taken from an upgrade to v9.0SP2 on a Cxi-II. There is a section where the licencing failed as it was disconencted from the network, therefore I licenced it offline for the time being as I had done that initially! LOG VIEW BELOW continued after the backup section (I have altered...

Disable your Firewall completely on your connecting PC and connect straight to the front of the controller. That section literally takes less than 2 minutes. I upgraded a few from a Windows 10 and Windows 7 machine! On a physical controller its normally around 1.5Hours (depending on the size of...

crich01 I've been looking for this for bloody ages! This works on Windows 10 as well! Thanks.

Maybe this will help on SATA Raid controller information.http://files.engineering.com/getfile.aspx?folder=5f648ad6-4e75-42df-89a6-30d1023a18c9&file=11_5191_00213_MXeIII_SATA_RAID.pdf

What's your Circuit Descriptor settings recomendations from the line provider for disconnection timer/flash timer in circuit descriptor asignment for that LS trunk your using? Suggest, you try to speak to them and let them know the 3300's settings so that the lines disconnect properly from both...

As above, -Either a Read only rs232 cable therefore unable to transmit the space input or, as Mitelmatt says hit space 3 times then Enter.

I know that to STOP that from happening you need to have the following flags set for each extension. Handsfree On/Off (Set to OFF)[Default = ON] Ring Intercom Always On/Off (Set to YES)[Default = NO] Transfer to Connect Allowed (Set to YES)[Default = NO] The above is to definitely STOP it from...

Can you define "Voice announce call"? Is it only on certain types of phones?

Is the console on a static IP address? If not can this done!Also,if it's not static IP then whats you lease time on the DHCP scope?

This can DEFINITELY be done on the Mitel system just for clarification+much,much more as with all the latest PBX's out there. Are you thinking of completely migrating to IP since you currently have a 10 Year old system? Then there are many choices for you! As long as your Data network is up to it!

There is an option in the class of service to save the handset volume change! Set this to yes for the specific handset!

Did you do a FULL install? or an upgrade? As you should do a FULL install if upgrading to version MCD 4.0 and upwards. This will then format your Flash Card to the proper patitions etc

Have you tried changing the Multiline set key assignment as follows of the DECT extension number in question on key 2 (i.e.Line Type = Multicall,Button Directory Number = it own extension number, Ring Type = ring) within the Multiline Set key assignment form so that the you can retrieve the call...

If I had the option then without doubt I would go for Mitel,but like KwbMitel said support is of vital importance. So that would more or less confirm my decision if it was between a STRONG LOCAL reseller and that of another SMALLER reseller which has only just STARTED to sell Shoretel...

See below for info.Note that option 125 is now used for updated firmware for Mitel IP Phones as its vendor specific for Mitel. Cisco Routers can be configured to provide DHCP services on the network. A typical customer configuration would be use the Cisco Router to provide DHCP services in the...