Recent content by whykap

the command is: write erase You will need to be in config mode. For more info: https://www.cisco.com/c/en/us/td/docs/routers/access/vg450/software/configuration/guide/vg450-scg/vg450-scg_chapter_01.html

you will need to delete the gateways from cucm and add them back in as MGCP. Same goes for the gateway config. Remove all the SCCP configuration and add the MGCP commands. Heres a link to configure MGCP...

The barge in feature is available in call manager: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/12_0_1/featureConfig/cucm_b_cucm-feature-configuration-guide_1201/cucm_b_cucm-feature-configuration-guide_1201_chapter_0100100.html

the transfer key will only be visible during a call. Is that the case here? The trf key is not available during a call? What version of CUCM?

is the finesse tomcat in service? If so go and double check your configuration one more time.

As gnrlash mentioned its probably delayed in the voice gateway. under the FXO port "voice-port" config there should be a ring number x command. lower the X to a lower number to get the gateway to answer quicker.

Imagine doing work in there right after someone had his taco bell mandatory explosion.

this doc will give you a good start on NFAS: https://www.cisco.com/en/US/docs/ios/dial/configuration/guide/dia_cfg_isdn_spcl_sgnl_external_docbase_0900e4b1806c752d_4container_external_docbase_0900e4b18216dd1c.html

Your format is probably wrong. Not sure why you're not setting that from the web admin pages but heres the CLI command book: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/cli_ref/11_5_1/CUCM_BK_CA6B8B0D_00_cucm-cli-reference-guide-115.html Hope this helps

What do you mean by default message? Main or opening greeting? make sure the phone line in cucm is in the correct partition and also has the correct vm profile assigned.

You dont need multiple line appearances in cucm to receive multiple calls. You can program a single line appearance to receive up to 200 calls. They all come in on the same appearance and they simply stack up and are visible on the display. Audible as well of course. That way you dont need multi...

are you just forwarding the internal extension of the users in question to their cell phones? Using the CFNA and/or CFA always on the line itself? If so that will not work. The hunt pilot will not follow that and over right it. Thats why you dont see the call going out. You will need to use the...

Oh yeah and heres the link: https://www.cisco.com/c/en/us/support/customer-collaboration/mediasense/products-installation-guides-list.html

Why do you want to install an obsolete product? Its EOL since 2017 and will be EOS sometime soon, if it already isnt. That said, heres a link with all the install guides available online I highly suggest however you look at another call recording solution thats still supported. Cisco uses AQM...

are you installing these to a CUCM? Then you can use the bulk admin tool (BAT).