Recent content by Trilinkcomm

i'm setting up a new IP office system in basic mode. I can't seem to figure out how to tell users how they can access their mailboxes remotely. I've come across people stating *7, *17 and a few others but nothing seems to be working. As of right now when you call in and get the auto attendant...

I just switched a long time customer over from POTS lines to SIP trunks. I guess I never noticed an issue because I almost always dial out using a 1+area code+number but they just brought it to my attention that they never had to dial a '1' prior to switching and wanted to see about getting back...

TouchToneTommy Thanks for the help. I ended up running the Upgrade Wizard to perform the upgrade and then uploaded the PLDS file. It worked perfectly....well, almost perfectly. Your tips worked perfectly but I guess for some reason a bin file for my lonely 1416 set didn't get installed on the...

I'm looking to see if someone can point me in the right direction. One of our customers had maxed out their IP Endpoint licenses and needed to add 3 IP licenses. Since their system is running on Rel 9.1.5, we needed to upgrade to Rel 11 in order to get the additional licenses. This is new to me...

I'm looking for some advice as to what might be causing this problem. I set up my customer's new office with 5 phones in his office and 2 remote phones (1616 phones) in his house. They work fine for a few days but then they lose their connection randomly. Each time he calls to say the house...

Westi... I think I finally figured it out. I have been working on my test system and started the hunt groups over from scratch. I tested as I went along step by step so I could find a point of failure instead of programming everything and then trying to troubleshoot it afterwards. I'll be going...

Westi...sorry about that. After reading all of the posts lately I kept thinking to myself why people don’t include the system info. I guess I’m just as guilty of it. The system is 9.1.7 (I think) and the VM is Embedded.

I've been searching for a solution and have come across several tips on what to do but it seems like I need a combination of tips and they don't appear to work together. Here's what I'm trying to accomplish: DAY TIME Ring at Hunt Group "A" (5-6 rings) giving users a chance to answer the call...

Code - 9N; Feature - Dial Telephone Number - N

I finally got it to work. I just had to create a short code and all is well. Thanks everyone for your suggestions.

Westi...I forgot to mention I already had the Trunk to Trunk Transfer enabled. Holdmusic...I just tried this and it doesn't appear x280 ever picks up the call. It just continues to ring. After trying to dial the HG, i then tried to manually dial x280 and it worked for internal calls but still...

Janni78....I'm not sure I understand. They might be calling from their cell phones or house phones. I also forgot to mention they only have POTS lines.

Can someone help me out and point me in the right direction. A customer of mine is a small doctors office and are looking to be able to perform this in case of an emergency. They're hoping to be able to dial into their system and pick up an outside line to make external calls. I know there are...

I'm not sure if this is the same issue I'm dealing with but I had 2 D160 handsets working on my system and everything was working fine. A few days ago we needed to change the IP addresses being used and now I just get "no service" on the phones. I've factory defaulted the base unit and then...

gknight1 - I did run the "run ipoffice verbose" command prior to stacking them. I'll have to try again on Monday to see if I can stack them first and then run the command. I know I'm getting off subject now but do you happen to know if there is anything special I should do with they're other 2...