I need to switch out a UPS that has three systems on it....a NORSTAR , OPT 61 and a Definity....I got the Norstar and the OPT 61.............HOW do I down a difinity and then bring it back up and stat it to make sure all is good???????
Just a squirrel trying to get a nut...
www.tmaxx.biz
How do I change time on a meridian and then check to make sure it will observe Daylight Savings Time next time around?
Just a squirrel trying to get a nut...
www.tmaxx.biz
Go into programming and assign the lines you want to each of the phones make them either appear and ring or just appear which ever you want.
Just a squirrel trying to get a nut...
www.tmaxx.biz
Thank you ltrievers, I guess I should have let that be known, I was taking that for granted....I did figure it out, it just took me two times longer than it should have...live and learn......
Just a squirrel trying to get a nut...
www.tmaxx.biz
I need to set up a SMALL call center consisting of three phones in an ACD group......Any one got a cheat sheet??????I havent done this in YEARS!!!!!!
Just a squirrel trying to get a nut...
www.tmaxx.biz
I need to set up a SMALL call center on a Norstar with a Call Pilot.....Can anyone point me to a good cheat sheet in order to make this go relatively easy??????
Just a squirrel trying to get a nut...
www.tmaxx.biz
I am adding a new group of 24 and I am trying to copy the programming from the first group...This is what I have done so far.....
ld 20
prt
tnb
and found 26 24 to be teh last tn in that group
then to ld 14
req new 24
type did
tn this is where I am not sure what to put in ......this loop 27...
John,
I have a working switch, I am replacing the IOP/CMDU card and I need to up load the software on teh new card....NTS told me I could not copy the software from one core to another....Do you know a way??????? Thanks in advance.
Robert
Just a squirrel trying to get a nut...
www.telemaxx.biz
Does anyone know where I can obtain an copy of the older release of 22.46 for an option 61 with older CMDU's with floppy drives ONLY........
Just a squirrel trying to get a nut...
www.telemaxx.biz
When I type in TID it gives me
TAPE ID:
LOADED D11867
DISK/TAPE
This is where I get confused.......
Just a squirrel trying to get a nut...
www.telemaxx.biz
How do I get the system ID or serial number for an opt 61....I tried in ld 22 but not sure if I did this correctly or not....Thanks in advance.....Robert
If you are paying .50 a piece for a 6-8" plenum tie wrap, you need to switch where you are buying them from. http://cableorganizer.com/mille-tie/plenum-mille-tie.htm
These are reusable plenum and work really well.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.