Recent content by SyedM

Thank you.

we are connecting on public IP.

Hello Everyone, We have a IPoffice R8 on dmz with SIP trunks and couple of IP and SIP endpoints. All devices are working fine except when we try to connect PHone Manager IP SoftPhone it dosen't discover; and there is no trace on Monitor. Need Help

Inbound calls are working fine but no out going calls..

Hello All. SIP trunk on BCM50 R6 configured as IP authentication. - RFC2833 set to 120 - RTP set to non signalling port set to 5060 - Public Sip Account Remote SIP domain assigned. - Dial plan set to public and "8" is assigned to BlocA - BCM is set to DMZ on service provider router

Figured it out.. In Embedded voicemail, i had Direct Dial-by-number checked, but didn't had KEY 2 (under actions) set to Dial by number. Apparently in embedded vm its mandatory. it works fine now.. thanks for all of your help. cheers,

I changed it to G.711 but no change.. and yes Dial by name is checked as well.

I have it set for RFC2833 but tried all three.

IPOffice R8(43) with SIP Trunks. Incoming calls directed to AA. No extension or Dial by name entry get recognized.

Thanks for your help hairlessupportmonkey.

It was the router causing calls to drop due to firewall. Lesson learned : Never use soho routers Thanks for all of your help.

this a basic Small business router, and doesnot have this feature available.

Outgoing calls also drops after 60 sec..

hello hairlessupportmonkey, i don't see this option in Manager 10. "Turn off SIP and H323 inspect maps - or formally called fixups."

ITSP have no information on this.. all they said configure the ip address and it should work. we are using Cisco RV082 router; port 5060 and all port are open from/to IPO.