Recent content by slatecom

I'd highly doubt that as the unit's programming interface is in English (with no obvious language change menu) and the accompanying system is also in English. I can't see where I can change the internal system prompts - they are all for incoming callers. How would I load English prompts into...

Hello everyone, I'm having trouble changing the language on a Panasonic TVS-50. I've reset the unit to factory defaults twice but absolutely every system voice prompt (when accessing the programming menus) is in French (rather than English), making programming the voice prompts difficult. The...

Is it possible to lock programming on a phone so that for example someone cannot program direct CO line buttons into their phone or change the BLF keys, like I could with the Norstar systems? Also, it seems that when a station is in use the all call page (33*) does not work - it says "busy"...

You were right, I had a look and it turns out that one of the cables in between patch panels was bad, going to replace them today. Thanks!

Hi everyone, I'm having this very strange issue on one particular extension. All other phones are working just fine on the same floor. Both the SLT and the proprietary phone are connected to the same jack on different pairs. The issue is that on a single line telephone (2554 set), the phone...

I believe that OS/2 Warp (version 3) has a maximum disk or partition size (can't remember) it can recognize of something around 2/3/4 GB, I once tried installing the OS on a 6GB drive with a small (500MB) partition and either it wouldn't install fully or it wouldn't boot. It could also very...

I've been looking for a SIP-compatible VOIP FXS ATA for a Nortel MICS system for a while know and came across the Linksys PAP2t. For low-medium usage applications it seems to be a good offering but I'm unsure of the compatibility with my system. The thing I'm mostly concerned about is...

In case anyone cares to know, after some effort trying to get the 7.1 cartridge to work (due to not having the upgrade kit, had to drain the capacitor), I brought the system up and the EATA seems to be working perfectly fine, even though it wasn't listed as being compatible. The "fake" dial tone...

Thanks for the link, didn't think of searching for a compatibility matrix. Looks like the EATA is incompatible with anything higher than 2.0, don't know what to do now.

Hello all, I'm about to purchase MICS software release 7.1. I've heard that the Enhanced ATA (the more rectangular ATA) is not compatible with anything above version 6.1. Here's what it looks like just so there's no confusion: http://www.meridiannorstar.net/images/products/ata1.jpg Is this...

I know about the software thing, what I meant was that people are selling systems that come with the newer 2-piece cartridge for around the same amount as just the cartridge itself, without any extras. Here's where I'm getting very confused. People are selling cartridges that say they're "2.0"...

What would be the earliest version that supports the M7100 telephones? I took a look on eBay and the prices for newer releases of the software are, as I would put it, outrageous, really. I think it's pretty funny how complete systems often cost about the same or less than just the software...

Hello all, I just acquired a Nortel MICS without any cartridges. Would anyone be able to tell me what software cartridge I should purchase for my system? The card I'm looking at purchasing is a NT7B72FG-93 but I'm not sure if it's compatible as I've only dealt with "simple" systems before...

After setting up an Exchange server, I have found that although I am able to send emails, when I check the test email using Hotmail, it appears that 9/10 times the "From" name appears fine when looking at the list of emails, but when I click to view the email, the "To" and "From" names are...

Oh, I'm sorry, I wasn't thinking when I read the title and somehow totally misread it as "CICS".