Recent content by Rhiuz

Hello Master, I have KX-HDV130 version 5 want to upgrade to version 8 i have install abyss web server, then i input file hdv firmware part1 and par2 in htsdoc but after upgrade in hdv130 web but error message : Error : Firmware version is fixed by configuration parameter. whats wrong with this...

Dear all master i have KX-TS845 but can not dial, i try using default password 1111 but no action, i think default password has been changing. how to clear the password dial lock? Regards Rhiuz

Hello obtsystem, 5 seconds clear audio but call drop (always, using H323), but if pickup 3 rings very good no drop (using H323). if using SIP all fine no drop. its 17 site using TDE NS & TDA but other PBX has 16 site with direct ext (no own PBX code) any suggets for 16 more site other PBX?

Hello Friends, I have TDE600 & NS300 using H.323 1. TDE600 call to NS300 rings (1) pickup then 5 seconds drop (H323) 2. TDE600 call to NS300 rings (3) pickup always drop (H323) 3. NS300 call to TDE600 rings (1) pickup then 5 seconds drop (H323) 4. NS300 call to TDE600 rings (3) pickup always...

Obtsystem did you have V6 NS series? u can try in NS1000 using port wan with public ip then if you open with HTTPS their need license

Hello Luiz ELCOT16 not use? already OUS that card? may be you can change other slot

Hello Obtsystem, I try using V5 & V6 cannot register, because V6 if you wanna remote NS with port foward PBX webbase they need license remote in NS series that is the problem 172.168.10.200 is not local range.so i must downgrade V5/V6 to V4.5 can you?

Hello Master, I need help how to down grade system KX-NS300 V5 to V4, Problem 1. Our customer do not want to change IP 172.168.10.1/24 ( because this not in range IP local 172.16.0.0-172.31.255.255 ) In V5 input ip 172.168.10.200(PBX), 172.168.10.201 (DSP)IP phone NT series can be register but...

Dear friends, i want to asking how to setup fax server on KX-NS1000 thanks Rhiuz

Dear friends, i want to asking how to setup fax server on KX-NS1000 thanks Rhiuz

digeteltlc, HTS series just for SOHO project, i think u can suggest KX-NS series because HTS just 2 countcurrent SIP MRG. so KX- NS1000 ;)

yes, SIP extension . already change port 15060/15X6X but still call from 100/101/XXXX. any solution?

u can set up walking cos

Only NS Series / HTS series have MRG(remote extension) TDE series & NCP series dont have MRG(remote extension) but you can using SBC for this series

digiteltlc, setup your wan with IP existing router. example existing router ip 192.168.0.1/24 so u must set WAN HTS ip 192.168.0.XXX gateway 192.168.0.1, then your LAN setup diferent segment ip 192.168.5.XX. PC------LAN HTS-----WAN HTS-----Existing...