Recent content by remchuk

AAM Storage and Application 7.1 ACM 8.0 All virtual I've searched 'message log' in the forums and couldn't find an answer. How can I view the life cycle of a single voicemail message? Specific to what I'm looking for... Message left on mailbox xxx a month ago, then forwarded to yyy a week...

AAM Storage and Application 7.1 ACM 8.0 All virtual I've searched 'message log' in the forum and came up with nothing relevant... How can I view the life cycle of a single voicemail message? Thank you

Booted October 2019 with a forklift upgrade of AAM, CM, SM, AES as v/m's on System Manager. Getting with SMTP folks soon. Will post back what's found. Thank you.

Internet Messaging: IMAP/SMTP Status Internet Message status: Running Percent of media space in use (contains queues): 11.0% Number of incoming messages in queue: 0 Number of outgoing messages in queue: 0 Messages in SMTP queues (defer/active/incoming): 228/0/0 Number of SMTP...

AAM 7.1 v/m storage Users complaining about not getting email notifications for many hours after message is left. Below is partial SMTP Log Summary: Internet Messaging SMTP Traffic Postfix log summaries for Apr 17 Grand Totals ------------ messages 1084 received 1106 delivered...

AAM 7.1 storage/application virtual servers Email notification works. However, I need to block emails going off site that are being sent by AAM storage. I only want emails to be sent to @group1 and @group2 and @group3. Everything else should be blocked. Can this be handled by AAM? Thank you

PerContactWaitTime

CM 3.1 SES 5.2 SIP trunks through Cisco CSME to SBC for outbound only. Trouble: Call originating on ACM 3.1 to Vz Wrless user. VzW user lets call ring to v/m and it fails with time out and fast busy. Test call to Vz user who hits red ignore button is successful to v/m. Also, 100% of all...

Get the following after enter: @S8500C> ps -eaf | grep sshd root 24414 1 0 Sep16 ? 00:00:00 /opt/ecs/sbin/hp-sshd -f /etc/ssh/hp-sshd_config dadmin 6607 5503 0 08:35 pts/1 00:00:00 grep sshd Still can not enable via web interface.

Won't be back on site til Monday, will try it then. Thx

Yes, tenet is open. I do not have root access. Hopefully it's not needed.

CM 3.1 8500 stand alone Contains: 01.4.642.1 Reports as: R013x.01.4.642.1 Release String: S8500-013-01.4.642.1 UPDATES: 01.4.642.1-13743 unpacked hot patch 13743 for 01.4.642.1 01.4.642.1-14881 unpacked cold patch 14881 for...

CM 3.1 8720 servers I have seen quite a few posts with no access to " * to program " on 4621SW's. None of the posts detail a solution. I have a number of them running 2.9040, 2.920a, and 2.930a. When the phone boots up the option for * to program has disappeared. It used to be there...

How'd you disable the test so the power alarms would retire?

A retired tech suggested that I wire my new (flat) battery pack parallel to a good (fully charged, in service) battery pack as an attempt to charge the new pack. What do yo think about this idea?