Recent content by pointedout

You are facing this problem within single cabinet or when you transfer the call to second cabinet. Do check out your VGWs status while facing this problem.

change DIDN to YES (LD 15) if you want your DN to be passed as well after HLCL Prefix, otherwise only HLCL entry will be passed... My Experience...

Just hit the spot. In CLS of Trunk TN, it was DTN (Digitone). I just changed it to DIP and things started working. I don't know why nobody though about that. Problem resolved. Thanks for your kind anticipation.

I have split 30 channels into 20 + 10. 20 are in one route and 10 are on other. This issue is happening on 10 separate channel. If IFC was the issue, other 20 channels must exhibit the same problem, what you say?

I have tried to loop back my Analog Ext as well to Trunk Card. Same thing. Analog set directly to trunk works perfect, and its on DTMF.

Doc, I have not a single post with 40 replies, trust me. I have tried Nortel documents, tried to read the old captures, tried reversing polarity, card slot, TN. I still doubt on my configuration and that is why I am asking you guys. There are some issues and thats why I can't call Vendor right...

Tried another XUT on 2 different slots. Nothing worked. Getting the tone, but not dialing. Any guidance plz?

I have a PRI with Ericson MD110. It was going fine however 4 days back we got an issue. External caller was not able to call on our Operator root (separate group of channels). Incoming call is coming in this manner: DCH 18 UIPE_IMSG CC_DISC_IND REF 00002FEA CH 18 1 TOD 16:08:36 CK 00D0C348...

ISMs for Mobilx separately? or we can use ISMs for IP Phones or Digital Phones for the purpose. Secondly, can you please point the details out for Rls 5.5j NTP?

So, is it possible to install a 2050 Softphone, forward all of its calls to my cell phone and use my cell phone as if it is a DN (at least caller will not be having any clue of all this), Right?

I tried crossconnecting a simple analog set directly to the MDF. It gives the dialtone and dials the number as well. Tried changing TN as well, nothing happened. Can it be the card fault? Any other check remaining?

I am asking if it is possible in CS1000E. RIGHT forum :)

I am not sure. Plz tell me how to go ahead with both options? I mean what will be the possible solutions if the trunks is loop start or ground start?

I once installed a BCM 400 with a softphone having Keep Alive option. What it used to do is that it just kept my Softphone working even if my notebook was powered off. I used to transfer all my calls from that virtually alive softphone to my cell phone. Just want to confirm if this option is...

I have Trunk Card X Univ Trk. It has been configured with the setting given below. I can have the tone but it's not dialing any number. I can hear nothing but the silence after dialing. What can be the issue? Given is the prt of root and TN: LD 20: REQ: prt TYPE: cot TN 8 0 10 CUST...