Recent content by PhoneGuy88

I know it's possible to do a logo on the 9600 series: http://voices.yahoo.com/how-customize-logo-screensaver-avaya-5976284.html?cat=15 Is it possible to do a similar logo on the 9508 digital phone? Ian

I got Broadcast working, thanks for your help! That's exactly what the customer wanted.

K, I set it for broadcast but the messages aren't forwarding to my members, the message stays in the group. The members have their boxes checked. I added the source number of the group to one of my users as a test and then the message did set off the user's msg lamp, but it was not in his...

Stats: IP Office 8.1.52 Voicemail Pro Their old system had voicemail groups where they could directly leave a message for an entire group of users. They had about 20 of these groups. I thought of creating Hunt Groups with a Voicemail Answer Time of 0 or 1 and then just adding the members to the...

I implemented 1043's solution and it works great. Thank you for the help, everyone!

I have a bit of a conundrum. Here's my setup: IP Office 500V2 8.1.52 Advanced License PRI Trunk There's a fax number that comes into my IP Office via the PRI, and I need to get it to a single fax machine. The fax machine is off-site, far away from the IP Office, so an analog connection isn't...

The system is running 8.1. I did it this way because the users in the system wanted a name associated with the number. The routing does work now, the hangup issue was caused by issues with my configuration.

I have technicians with cell phones that need to be accessible from our phone system. They will not have desk phones and they won't have voicemail since they are out in the field. I thought a simple way to setup a method to call them would be to: Create User>Assign Extension>Setup...

Still nothing. Talked to Catalyst and we're gonna RMA it. Thanks for your help!

What's the restart command? The LED is continuously flashing green. If I run the command for assert current map, it says: Panic at 7885142ms BUS Fault occured

If saw earlier in my post, I linked to intigrant's FAQ as that is what I used to rescue the first module. What other options do I have? No AT commands are recognized.

Got my licenses validated today, unfortunately the expansion modules did not detect. I called my support provider (Catalyst) and they said I was following the correct detection procedure. But even erasing the config on the IPO wouldn't detect the modules. To make things worse, halfway through...

Thanks, I will re-check after my licenses are verified.

1043, I will try your solution and let you know how it goes when we cutover next week.

Pretty much all my licenses (aside from IP endpoints) are invalid at the moment until Avaya verifies them. I just didn't think that would impact the detection of a module.