Recent content by OroITDirector

Exchange 2003 SP2 on Windows 2003 R2 standard DC/GC windows 2003 R2 DC/GC Windows 2000 sp4 We have the 2 mail connections over https and the public folders over https, but we can't get the directory to connection through https. I have added the registry entry on the windows 2003 DC/GC and the...

Added note..., a reboot of the router fixes the issues until the NAT translation changes again. I can't see any time patterns either.

We have just installed a Cisco 2801 with dual T1s for our data connection. It then runs to a Sonicwall TZ170 and then to the network switch. We have an internal mail server with a public address of 64.##.##.## that NATs internally on the Cisco router to a 10.0.1.##. Every so often, the NAT...

Because we never knew we had to switch. Can we still install on pervasive 2000i or do we need to move to v9x? If so, is that hard to accomplish?

Does anyone know if this combination will work? We have been on PSQL200i SP4 for a while and are currently running Progression 7.6.4c. Thanks.

I selected the Servername and selected properties. Set Authenticated users to Read. At the mailbox level below, it still has Authenticated Users with Full Control. Should I match the permissions at the servername level on the mailbox level below?

Just spoke to telco and they said: "The T-1 itself is actually Layer 1. The protocol we are using PPP is layer 2. Its layer 2. Should we do any multilink functionality it would be delivered layer 3. Layer 1 & 2 are the standard." I guess that means I need a router at the warehouse and a...

The interface box at hq is a rj45. Is there a way to tell if it is layer 2, or ask telco? I will have to have 2 routers at hq and 1 at remote warehouse if it is not layer 2?

We have a ATT T1 (ISP) that connects to Cisco 1721 that connects to SonicWall TZ170 at our headquarters. We want to bring our remote warehouse (2.5 miles) away on to our network at the headquarters. What other hardware is needed? We are going to get a point-to-point circuit from our telco...

Is a point to point connection just a spanned connection of a site that exceeds the ethernet limit? If I plugged a network cable into a workstation at the remote site then connected to the ibterface provided by telco then plugged a cable into interface provided by telco into a network switch at...

Yes, our hq router is connected to firewall.

I have some older Cisco routers that we are using onsite. Our local telco is provisioning a point-to-point frame relay connection tomorrow. We currently have a Cisco 1721 with a WIC1-DSU-T1 V2 that connects our T1 to the Internet. The other Cisco 1721 router that is going to be installed at...

We have Progression 7.6.4b and have noticed that new employees created that are being paid for the first time do not have the OASDI tax or medicare tax. The report shows the amounts correctly for the employer but not the employee. Any thoughts?

We just started getting the following error: Error 046 on file GLTRXHST.BTR Message #0446 What could be causing this error? I checked the file on the server and it is rather large at 482MB..., should this file be that big?

Where, on the mailbox itself or in System manager, Org, Server, Mailbox Store, properties, Security?