Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by NextProblem

  1. NextProblem

    Nortel 3x8

    thanks to both, I'll make sure it is set to tones and follow up with 808 if I need to. I only have time to do it right. I don't have time to do it twice!
  2. NextProblem

    Nortel 3x8

    Ok folks, it's time to get into Professor Peabody's way back machine. I have a customer with a Nortel 3x8 (DR1 I think), when they are on a call connected to a device looking for DTMF they can press digits all day long but there is no response at the other end. Do I have the ability to change...
  3. NextProblem

    Aux Bell on IP set

    I have a customer with a bcm400 running acd software. All phones are IP phones. They need an aux bell to ring on ext 242. The aux bell I have is a standard analog unit. I came off of an analog port and made the bell ext 427. I could not assign an answer dn key because there are not buttons on an...
  4. NextProblem

    BCM 400 Cooling Fan Light

    Thanks 1082. I only have time to do it right. I don't have time to do it twice!
  5. NextProblem

    BCM 400 Cooling Fan Light

    Going out to replace a BCM 400 cooling fan today. Not sure if the red light will go out when the fan is replaced or if there is a reset command that will need to be entered. Also I have read that I can replace the fan without powering down the system, anyone have any further input on that...
  6. NextProblem

    BCM 50 - Direct calls for extension going to reception

    Hi Folks, I have a network of 3 BCM's and just added a fourth. The new switch is a BCM50 and draws its dial tone off of a PRI on a BCM400. The phones on the new switch have dn's in the 5400 range and DID's with the last 4 in the 7000 range. When I dial a DID I go directly to the correct phone...
  7. NextProblem

    BCM 400 IP trunks disabled

    I have two BCM 400"s and two BCM 50"s all linked together. 4 digit dialing between all switches has been working for some time now. Suddenly the IP trunks on both 400" show a state of N/A on Bus 0 under telephony resources, resulting in the inability to 4 digit dial. I am not able to enable and...
  8. NextProblem

    Partner ACS Group Calling & Hunting

    I have a customer with an ACS,they have 2 groups of 3 phones each(calling groups 1 & 2). All incoming calls are answered by the AA. Pressing 9 performs a direct extension transfer to 71(calling group 1). If unanswered the customer wants the call to go to the second call group (72). I tried to...
  9. NextProblem

    Find software version - ctx 100

    When using e-manager where will I find the software version for my CTX 100?
See more

Part and Inventory Search

Back
Top