Recent content by newBPhoneGuy

yeah i know that you can also ghost them then change the wwid but i want the software i can actually install but it doesnt look like thats going to happen. thanks for the info

Hello everyone, Is there any way o get a flare recovery file and a flare install file, not the upgrade. i want to take 5 disks and install the flare from scratch how is this possible? Thanks for the help

replace the fan with a 1500sc they probable wont be that expensive and they are very easy to repalce

POST

the slot seems to be bad i would try to put a disk in another slot configure the driev as a hot spare and see it is rebuilds

wrong type of scsi cable?

do you know how to tell which version i have

hello, I have a partner acs R7 system with one on those little plug in voice messaging card and i was wondering how many mail boxes i can setup on it.....i would like to do about 8 if that is possible do you know about how many messages each box will be able to hold thanks for the help

ok so i have a powerdge 4350 with a perc2 card connected to a powervault 200s.........we have it set one so it uses only one eem on the pv200 , about 6 months ago we started getting these errors stating the temp probe 0 was dropping below the minimum threshold which is like 0deg cel which is...

oh and i only want the voice mail to pick up if i transfer the call to the extention and they dont answer in 4 rings

Hello, I have the PARTNER ACS R7 and i want to add in the voice messaging pc card so that i can setup voice mail on one of the extentions.....can someone please help me and tell me the steps i need to follow inorder to get this to work??? Thanks

yeah i know all that thanks for the help though..... I think it might have some hing to do with the firmware chip our vendor sent me 3 ore boards and they all work fine of couse i did make them test them on the same system i am using so......other than the firmware chip i cannot think of...

yeah everythingis connected Im thinking maybe its possible that it is an imbedded firmware issue or something nbut i cant figure this one out.....

hello im trying to install a remote insight lights-out board in my dl360. i have tried two different boards and on bothe of them i cant get the keyboard to work. I have tried it with all cables pluged into the board and all cables pluged into the system and no keyboard either way. the mouse...

oh hahaha sorry i thought you said "make a model"...... all it says is Fibre Channel SAN Switch/8 with Fabric Operating Software 158222-B21 sorry about that thanks