riloe with the dl360 g1

[newBPhoneGuy]

hello im trying to install a remote insight lights-out board in my dl360. i have tried two different boards and on bothe of them i cant get the keyboard to work. I have tried it with all cables pluged into the board and all cables pluged into the system and no keyboard either way. the mouse works fine i can logon from another computer cause i cant assign an ip caust i cant the the keyboard to work......when i first turn the system on the 3 lights ont the keyboard flash like normal but it never works.....if i let it boot all the want to windows login the mouse and monitor wor but no keyboard....i have had everything working on other boards it just seems funny the these 2 board would both have the same problem......any ideas

thanks

 

[TheLad]

Have you connected the internal cable from the lights out board to the connection on the system board?

See page 3-3 in the PDF document link below:

http://h20000.www2.hp.com/bizsuppor...169616-006_rev6_us/TPM_169616-006_rev6_us.pdf

--------------------------------------
"Insert funny comment in here!"
--------------------------------------

 

[TheLad]

Sorry, link above does not work:

http://h20000.www2.hp.com/bizsuppor...169616-006_rev6_us/TPM_169616-006_rev6_us.pdf

--------------------------------------
"Insert funny comment in here!"
--------------------------------------

 

[newBPhoneGuy]

yeah everythingis connected Im thinking maybe its possible that it is an imbedded firmware issue or something nbut i cant figure this one out.....

 

[blister911]

We don't have any DL360 G1 server's, so I don't know if this is relavent or not. Some servers will only work properly if the RIB-LOE is installed into a specific slot in the server. I think it needs to be in the 32-bit slot.

 

[terry712]

dont have anything that old either
rilo's used to have to go into the last slot or first slot pending on orientation - it should be written on the underside of the lid

tended to be the one at the end of mb

 

[newBPhoneGuy]

yeah i know all that thanks for the help though..... I think it might have some hing to do with the firmware chip our vendor sent me 3 ore boards and they all work fine of couse i did make them test them on the same system i am using so......other than the firmware chip i cannot think of anything else..... plus the firmware chip is kinda outta my control so i like the idea of the problem being that rather than ME...lol

thanks guys

 

[JockFrog]

HI,

Get the latest bootable firmware CD from HP. Start the server and check its all okay at this level before doing anything else.