Recent content by murphysmom

CICS with CP rings set to 3

Cannot get into voicemail account reset password allows access to mail box you can do a forced change of password go out and Feature 981 gives you access denied again

Wayne wouldn't that also be true of the extrernal call dialing thru the system to the same extension that doesn't get the forward to voice mail when called by an internal set. I have lots of phones that don'r have a forward to aextension that representsa the vm..it still gets there

MICS 6.1 50 sets ext 295 revieves emails left from external calls dial the same extrension internally it just rings and never goes to voicemail

Startalk with CICS 4 lines for company 1 (C1) 2 lines company 2 (C2) 4 lines A&P five sets C1 2 lines A&P 2 separate sets C2 no issues with C 1's lines C1's the 1st 4 lines are set to table 1, greeting 1, prime set 21...works fine C2's the 2nd set of lines set to table 2, grt 2...

I have a BCM50 on a network the router has DHCP...if I have to disable one...can it be done on BCM50...oir does it deactivate itself?

It was the punchdown...started on pin 14 instead of 25 Thanks for all the help.

Oldestgeek That is probably it.

Dasheen thanks for the question This is a BCM50 with 4 lines and 8 extensions,& 4 VM The lines all have dial tone on the Butt phone...all are cross connected to pins 1,2,3 & 4 respectively on the 1A comb that is the only J12 on the system....no extra modules....I can get into the system with...

Dasheen thanks for the querstion The linbes all have dial tone on the Butt phone...all are cross connected to pinss 1,2,3 &4 respectively on the 1A combe theat is the only J12 on the system....noe extra modules....I can get into the system with SETNNA and see the line s assigned there too Put...

YNOTPHONR yes 4 lines are in pool A

These are loops starting at 061 to 065

BCM 50 installed all sets showing...lines show in element mgr as appear and ring...phone shopw lines on Feature *0 No dial tone

Have BCM 50 looking to install element mgr on Vista

If I call in on a line I get the AA fine...then while tying up those lines...I call in while first call is on AA I get AA.... If I call in on e one line and then call in on a second...before the first call gets to AA...I get GD immediately on the second answered call?