Recent content by mrclean0613

Ok... Here's what I have for LD 137 STAT HSP & STAT ELNK .stat HSP LCS HSP STATE is DOWN HSP LINK CARRIER: OK Auto Negotiation: Enabled Auto Negotiation Completed: YES Actual Line Speed: 1000 Mbps Actual Duplex Mode: Full Duplex Ethernet (gei unit number 1): Internet address: 127.2.0.2...

Hmmm ~ Not sure of these acronyms... what is HSP? You have already probably figured out my answer to the next question. I do not have access to PDT

Hey djk205 ~ Are you saying these errors are pointing to an elan port? the errors appear to be pointing to the CPU-0

Greetings ~ I have a CS1K-E kicking out SRPT errors - it looks as if CPU-0 is defective or something on CPU-0 not feeling well. I have attached the HST file to show exactly what's going on. Looking for some guidance on a resolution > Would an INI possibly clear this? What happens if there’s...

Ah shoot - ya know - these are i2002 sets. So the menu is different - I now see on the i2004 sets where I adjust this. Not too certain if I can do this on the i2002 sets

Greetings ~ Where do I make this change? Does this entail a system reboot? Can this be phone dependant or is this system wide? The current setting is Nortel-i2004-A from 10.1.X.XX XX.XX.XX.XX:4100,1,5 Is there a way to adjust the retry to 10? Thank You, mrclean613

Hey there Wane47 ~ I'm referring to the Alarm/Fan module (NTDU64) On the inactive CPU Alarm/Fan module (NTDU64) Here are the lamp conditions on the Alarm/Fan module System LED = RED Power LED = RED The other two LED's = GREEN On the Active CPU - Alarm/Fan module All four LED's = GREEN...

Hey there Wane47 ~ Do you happen to have a CS1000E? Would you happen to know what the normal lamp conditions are for both Call Server CPU-O & CPU-1 are supposed to be? Is the inactive side suppose RED on the Power and System LED?

I appreciate the feed back I'm familiar with the Paddle Boards on the Legacy Nortel Opt81C - CS1000M (several columns) architecture However, this issue I'm having is on the Nortel RACK MOUNTED CS1000E - this is the Call Server Architecture

OK - Here's what I get - I don't believe there is no System Monitor on the CS1000E Call Server stat cpu cp 1 16 PASS -- ENBL TRUE REDUNDANT DISK STATE = REDUNDANT HEALTH = 20 VERSION = Jul 28 2005, 04:14:02 Side = 1, DRAM SIZE = 512 MBytes cp 0 16 PASS -- STDBY TRUE REDUNDANT DISK STATE...

how do I verify the NET card is ENBL?

Yeah - no luck there I did see mention of SCPU to get the system running on CPU-1 > then trying to initiate the ENLL Not too certain and I need to do this maintenance after hours. I prefer to know what to expect before hand

It's a VGW - loop 16 running in core-1 - Active CPU-0 What are my options? What effect is this loop being DSBL having on the system? Can I lock the Core-0 and work on this loop 16 without an interruption to the system... INI or Reload - can't have an interruption during production hours...

Unable to restore this loop These are VGW trunks for the most part REQ: stat 16 SUPER LOOP DSBL RESPONDING Any suggestions are appreciated - all maintenance needs to be done after hours - I'm trying to determine the current effect of this loop being out of service?

CPU-0 side is all GREEN lights So, you suggest an INI - do I need to swap CPU's to get it on CPU-0, then INI the switch? Or can I initiate the INI on CPU-1?