Recent content by mmori7

Hardware version

I had the same problem few months ago, there are a hardware issues with combo trunk card. If your card is pcs05 replace it for a pcs07

Ok, every 9620 working well, can dial Toll, but still have ring no answer on all 1120 when tried to dial 1XXXXXXXXXX.

Ring no answer.. sorry, when we dial toll number from the same site as the 1416 we get a ring no answer but I see the right number goes out from SSA. Thanks

remote.. Shortcode 9N N 50 ARS 50 1N 91N 31 and once again, the digital phones works for all calls but still have the issues with sip 1120 phones..........isdhviodjnca :) Mick

Ok I can make 1N calls with the 1416 but not with the 1120, they are at the same remote site and they use the same outgoing patern. Thanks

Yes I did The 1416 can dial every number: toll, local and 18xx...... The 1120 can dial the same but not the toll number???? (1N) I'll try it thanks Amrid

I can see the call out from site B correctly it go out on the PRI at site A same as the other call.

Hi everyone SCN IPO 8 0 16 Here’s my problem Site B dial over h323 trunk to dial out on PRI site A Site B use 2 1416 and about 20 1120 The 1416 can dial every number: toll, local and 18xx...... The 1120 can dial the same but not the toll number???? They use the same pattern to dial out...

Finnaly I was able to put it back to last version with DTE AT commands and Manager BOOTP with the right information. the last config was with the mac add of WAN port, so to be sure I have the right MAC/port setting I did a ping for each of them an than a ARP -a. At the begginning, the IPO 6.1...

Depending on wich release, there are a chek box for secondary dial tone.

yeah, there was an license for software upgrade but just 6.0 to 6.1 shit, now I need to renicialize thru the rsr232 port, the IPO is dead.

Can I do something with the cf Card and the dte port?\

My bad Just try to upgrade ipo 500v1 6.1 to 7.0.23 there are something to do??? I think I need a new IPOffice

Hi all Just install ipo 7.0.23 VMPRO and HTTP srv, everything working but on those phones (96x1) the Message Buttons, Contact and Call Log buttons don't work any idea thanks