Recent content by mjwald

Cool, thanks for the tip. Yes, CP and Contact Center are both gone now. Will be doing the same for a 1000e in a couple of weeks. Love changes.

We are replacing the old data switch that our 1000M is using. We know that all out IP phones will go down, but what happens to the cores when they can no longer communicate?

Thanks for that, reversing the polarity did not do it. Called the vendor, going to let him figure it out :)

So I am trying to get hook flash disconnect supervision to work. We have quite a few emergency devices out and about that require disconnect to drop the line, most are happy with loop reversal to do this, and it works great. Our elevator phones however, want the hook flash disconnect. But it...

just add the hunt DN line to the users extension mobility profile. the mobility profile that makes his cell phone ring should not change. All should be good.

never heard of it, however I would be very interested. Let us know how it turns out.

ReallyRotten, Been rather busy the last week or so. SO slow getting back to you " Do you the correct interfaces set up (i.e. g0/1 is bound to the service provider and g0/0 is bound to CUCM). Hope this helps." in short NO. I was not even using two interfaces, all communications are running...

I am trying to get a 2811 to register with voip.ms, can't quite get it. It does not even appear to be trying to register This is what i have below On the voip.ms site they have a config guide for IOS 15.1, but I am still running 12.4 and more then a few of the commands do not work for me...

Sorry for the slow response Yes I have seen that. However it was written for ios15. I am running 12.4 and more then a few of the commands do not work.

I am trying to get a 2811 to register with voip.ms, can't quite get it. It does not even appear to be trying to register This is what i have below version 12.4 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption ! ! ! voice service voip...

I have 3 win 7 machines that I have created a restore point on, and every week we restore those machines to that restore point. Is there a way to have the machine do it automatically? Say every Friday at 10PM Thanks Much!

thanks

OK, so what about DN 7555 rings as cadence 4 on 5 phones and DN 5500 rings cadence 2 on the same 5 phones and their prime DNs ring whatever DRG is set to. Would that work? FYI we are 7.62, I think the patches are current, if not they are darn close.

Thus I tried it on the 2008. Any thoughts?

If you have uccx, you could write a basic script that will do that.