Recent content by Levitra

I need to order replacement inside small fans for an S8500 (A) does anyone have the part numbers?

Thank you the config may help, but I cant even get a ping response from this board. I tried your process, but no joy. Thank you for your help and the config info may help to rule out any oversight on this, but as this config worked with my old board and I can contact it over VAL Manger via the...

I can connect and change messages from VAL manager and the port link light is up on my switch, however, the TRMT light on it is dead and the RCV light is on and I can see the ping blinking RCV. Could there be something in set-up I have wrong or is it a bad card. And of course ann back-up and...

Got a repaired card in my inventory which is a 617C49 which cliams to be upgraded to R4.0, how can I confirm SW version on this Messaging system? Thanks in advance.

Where do I get the software to reload this NTDU27AB back to factory and how do I do it?

Momentary lapse sorry. Feature 59 does it... I could remember . TY.

Assuming outside clamshell has been replaced and non of the information is correct. TY in advance.

I want to add a shelf and have a J58890BB-4, L4. Will it work in place of a J58890BB-3 ? Thanks.

Thanks Mitch that was it. The IP on the V3 was transposed. Odd that the switch would not recongize the board with the IP being wrong. - Thank you kindly.

My CM 4.0 Will not see the mm760 in v3 of my G700. The MGP will see it and I was able to successfully update firmware on it,; however, I get board not inserted in CM 4.0. I have tried 3 board 1 white and 2 gray faceplates, all with the same results. I added in board in config, but no...

Yes, it seems a 12V regulator chip is blown on the board. Now to source the part. LOL Thank you kindlyfor you response. But my question is: Is(are) there a reference document(s) that lists the LED flash codes for BCM Modules?

I have a GASM8 in my BCM50 which has the power LED flashing, alternating from red to amber. The status ight is solid green. Any reference documents on these codes? Thank you for your time.

My auto attendant will stop playing in the middel of the greeting and not forward to menu. Call Phantom ext. internally of AA short code works find it is only with incoming calls (of course the most critical.) Sell log below. And thank you. BChan: slot=2 chan=4 259115833mS CMTARGET...

Got it it was a bad TN570 and a bad port setting on my Nortel switch. TY

I am running G3si v9 Link Number: 3 Link Status: ethernet disconnected Link Type: ethernet Link Name: TN2501 - 01a11 Service Port Location: 01A1133 Service Port Data Extension: 522 Service State...